Главная
Skipped breadcrumb items
Multiclip 47 DAE
Инструкция по эксплуатации Страница: 133

Главная
Stiga
Multiclip 47 DAE
Инструкция по эксплуатации Страница: 133

Stiga Multiclip 47 DAE — maintenance and Troubleshooting Guide for Equipment [133/440]

Превью страниц Страница 133 / 440

Stiga Multiclip 47 DAE [133/440] Start when using the switch type i handle

EN - 13

13. MAINTENANCE TABLE

Intervention Frequency Notes

MACHINE

Check all fasteners Before each use par. 7.4

Safety checks/check controls Before each use par. 6.2

Check the guard and the

side discharge chute

Before each use par. 6.2.1

Check the cutting means Before each use par. 6.2.1

Check the battery

charge status

Before each use *

Recharge the battery After each use par. 7.2.3 *

General cleaning

and inspection

After each use par. 7.3

Checking for any damage to

the machine. If necessary,

contact the authorised

service centre.

After each use -

Cleaning the air lter Once a month par. 7.6

Cleaning the transmission 1-2 times a year par. 7.5

Replacing the cutting means - par. 8.1 ***

Drive adjustment *** **

* Refer to the battery/battery charger manual.

** The operation must be carried out by your Dealer or a specialised Authorised Service Centre

*** Operation to be performed at the rst signs of any malfunction

14. PROBLEM IDENTIFICATION

If problems persist after having performed the above operations, contact your dealer.

PROBLEM PROBABLE CAUSE SOLUTION

1. The engine does not

start when using the

switch (type "I" handle).

Safety key is not inserted or

is inserted incorrectly.

Insert the key (par. 6.3).

Battery is not inserted or is

inserted incorrectly.

Open the hatch and check that the battery

is tted in its housing correctly (par. 7.2.4).

Low battery. Check the battery status and recharge

if necessary (par. 7.2.3).

The engine does not start immediately. Keep the switch control pressed

for 1-3 seconds (par. 5.2).

The thermal protection has tripped

due to overheating of the motor.

Wait for at least 5 minutes and

restart the machine.

2. The display does not

start when pressing

the power button (type

"II"/"III" handle - Ad-

vanced Series).