Hikoki C10RE [3/45] Product specifications

– 3 –

English

To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.

This table saw is wired at the factory for 230 Volt operation. It must be connected to a 230 Volt / 6.5 Ampere

time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or

damaged in any way. Before using your table saw, it is critical that you read and understand these safety rules.

Failure to follow these rules could result in serious injury to you or damage to the table saw.

WARNING

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains

exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such as

dust masks that are specially designed to filter out microscopic particles.

PRODUCT SPECIFICATIONS

MOTOR SAW

Type ........................................ Universal Table Size with Extension................. 970mm x 890mm

Amps ....................................... 6.5A Table Extension ................................ Left, Right, Rear

Voltage .................................... 230V/50Hz Rip Capacity ..................................... 130mm R x 185mm L

Watts ....................................... 1600W (S6, 25%,10min) Blade Size......................................... 250mm

No load speed ......................... 4800min

-1

Rip Scale .......................................... YES

Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the

EQUIPMENT. This can influence other equipment (e.g. blinking of a lamp). If the MAINS-IMPEDANCE Zmax <

0.3 OHM, such disturbances are not expected. (In case of need, you may contact your local supply authority

for further information).

ENVIRONMENTAL PROTECTION

min

SYMBOLS

Noise can be a health hazard. When the noise level exceeds 85dB(A), be sure to wear ear protection.