AXIOMET AX-903 Расширенная инструкция онлайн [3/6] 528182

Introduction

• The unit uses electronic signals to locate the position of studs, joists or live AC wires through dry

wall and other common wall materials. Once the edge of the stud has been detected, the unit LCD

display gives visual and audio indications that allow you to easily pinpoint the stud’s edge position.

A pencil line allows you to quickly note the location of the stud edges.

• The unit generates a laser plane vertically and pivoting 90 degree clockwise or counterclockwise

to generate a laser straight line.

• The unit allows the user to locate wood and metal studs up to 3/4 inch for metal and wood stud.

• The unit provides automatic calibration for metal and wood stud modes, auto shut off and heavy

duty ABS construction.

• Detection mode is selected by keypad function – metal and wood stud. Default mode is wood stud

detection. Mode should be selected before “on” key is pressed.

Operating Instructions

Battery Replacement

Open the battery door on back of unit and connect a 9-volt battery to clip.

Place battery back into case and snap battery door on. Recommended to replace with a new 9-volt

battery when low battery indicator is on.

Calibration

Calibrate the unit on wall before scanning for wood or metal stud.

Note: While calibrating, the unit must not be placed directly over a stud, dense material such as

metal, wet or newly painted areas, as this will prevent the unit from calibrating properly. If this is

done over wood or metal stud, the unit will give no indication when moved away from the area.

Move to a different location and try again.

1. Hold the unit flat against the surface, making firm contact. Press and hold the “On” button.

All indicators on the LCD are displayed while the unit goes through its’ 1 to 3 second calibration

cycle. When calibrated, a beep will sound and LCD will indicate, as shown on illustration 1.

ILLUSTRATION 1