EXTECH MA61 [11/21] Fig 7 resistance and continuity measurements

MA44x‐en‐GB_V1.0 8/16

ResistanceMeasurements

WARNING:Please remove power to the circuit under test and discharge all capacitors

before taking resistance or continuity measurements. The meter will display OL if the circuit

under test is an open circuit of if the measurement exceeds the maximum range of the meter.

Do not input a voltage >30V AC or DC.

1. Turn the function switch to the Resistance Ω position.

2. Use the M (mode) button to select the ohm Ω display symbol.

3. Insert the black test lead banana plug into the negative (COM) jack. Insert the red test

lead banana plug into the positive (Ω) jack. See Fig. 7.

4. Touch the test probe tips across the circuit or part under test. It is best to disconnect one

side of the part under test so that the rest of the circuit will not interfere with the

resistance reading.

5. Read the resistance in the display. The display will indicate the proper decimal point and

value.

6. The MAX‐MIN function is available in this mode on the MA443 and MA445. Short press

the MAXMIN button to step through MAX MIN readings. Long press to exit the mode.

NOTES:

For low resistance measurements, the probe error (0.1~0.2Ω) should be zeroed using the

relative mode. Short circuit the test probes and press the REL button before taking

measurements.

When measuring resistance >1MΩ the meter may require several seconds to stability the

displayed reading.

MAX-MIN

For MA443 and

MA445



Fig.7 – Resistance and Continuity Measurements