Biostar M7VIW [20/31] M7viw bios setup

M7VIW BIOS Setup

Select Enabled if your system has a floppy disk controller (FDC) installed on the

system board and you wish to use it. If install and FDC or the system has no

floppy drive, select Disabled in this field.

The Choices: Enabled (default), Disabled.

Onboard Serial Port 1

Select an address and corresponding interrupt for the first and second serial ports.

The Choices: Disabled, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,

Auto.

Onboard Serial Port 2

Select an address and corresponding interrupt for the first and second serial ports.

The Choices: Disabled (default), 2F8/IRQ3, 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3,

Auto.

UART Mode Select

This item allows you to determine which Infra Red (IR) function of onboard I/O

chip.

The Choices: Normal, ASKIR, IrDA (default).

UR2 Duplex Mode

Select the value required by the IR device connected to the IR port. Full-duplex

mode permits simultaneous two-direction transmission. Half-duplex mode

permits transmission in one direction only at a time.

The Choices: Half (default), Full.

Onboard Parallel Port

This item allows you to determine access onboard parallel port controller with

which I/O address.

The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

Parallel Port Mode

The default value is EPP.

SPP (default) Using Parallel port as Standard Printer Port.

EPP Using Parallel port as Enhanced Parallel

Port.

ECP Using Parallel port as Extended Capabilities

Port

ECP+EPP Using Parallel port as ECP & EPP mode.

ECP Mode Use DMA

Select a DMA Channel for the port.

The Choices: 3 (default), 1.

Game Port Address

Game Port I/O Address.