Ardesto WMS-6118W [67/92] Attention do not connect to hot water

Содержание

EN Washers should be connected with water inlet Please use attached new plumbing rather than the old In order to ensure the quality water injection tests are carried out before the washer leaves factory so there may be water inside the internal tub door seals and door panel which are normal Water inlet connection Use the standard faucet ATTENTION Do not connect to hot water standard faucet 30kPa and 1000kPa longer faucet 2 Don t abrade the screw thread when connect the inlet pipes with valves square faucet 3 Please install dropping equipment if the pressure of supply water surpasses 1000kPa Two seals are supplied in the connectors of both ends of the pipe to prevent water leaking Turn on the tap and check if the connectors leak Check the pipes regularly Please change them if necessary t ber9ask t Make sure the pipes don t be damaged or twine with each other The connection of inlet pipes and taps water pipe connector I Check the rubber seals on both sides of the hose 2 Connect the water supply hoses to the water faucets tightly insert a rubber seal into the threaded fittings on each by hand and then tighten another 2 3 turn with pliers hose to prevent leaking Connect the blue hose to water faucet Rubber seal Ifl illll Water hose To water inlet on the washing machine 3 After connecting inlet hose to water faucets turn on the WARNING Do not overtighten Damage to the coupling can result 4 Connect the hoses to the water inlet tightly by hand and water faucets to flush out foreign substances dirt sand then tighten another 2 3 turn with pliers or sawdust in the water lines Let water drain into a bucket and check the water temperature Water inlet A WARNING Do not overtighten the hoses Overtightening can damage the valves resulting in leaking and property damage 5 Check for leaks by turning on the faucets If water leaks check steps 1 to 4 again 13