Planet IDL-4802-48 [7/20] Hardware installation

Hardware Installation

The PLANET IDL-4802 is a 1.5U high box-type IP DSLAM with rack-mountable

enclosure. It can be installed in a standard 19-inch rack by using the mounting

brackets provided. Mount the shelf on the rack using the large screws provided.

STANDARD

FRONT MOUNT

FRONT

MOUNTING

BRACKET

MOUNTING

BRACKET

The procedures to connect and wire the system are as follows,

1. Power and Ground Connections

Power Connections

With IDL-4802, connect the AC power cord to the AC supply socket on the rear

panel as below gure, and plug the cord into the external power source. The

voltage must be 100 to 240V AC.

With IDL-4802-48, the DC power interface is a 4-pin terminal block with polarity

signs on the front panel as below gure.

It can be powered from two –48V DC power supply. The DC power connector is a

4P terminal block; 2P is for accommodating one DC power input and other 2P is

for accommodating another DC power input. The DC power should be connected to

a well-fused power supply.

After completing chassis installation, please apply power to the fused power

distribution panel feeding the chassis. When using a DC voltmeter, please check for

proper voltage: -60V ~ -36V DC, and make sure that the polarity is correct.