Philips HR1861 [7/124] English

- Only unlock the clamps after you have switched off the appliance and the lter has stopped rotating.

- Do not operate the juicer for more than 40 seconds at a time when juicing heavy loads and let

it cool down sufciently afterwards. None of the recipes in this user manual constitute heavy loads.

- Do not remove the pulp container when the appliance is operating.

- Always unplug the appliance after use.

- Noise level: Lc = 75 dB [A]



This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Preparing for use

1 Wash all detachable parts (see chapter ‘Cleaning’).

2 Pull the mains cord out of the cord storage compartment at the back of the appliance (Fig. 2).

3 Place the juice collector into the appliance (1). Place the pulp container by tilting it forwards

slightly (2). Insert the top end of the pulp container rst and then push home the bottom

end (Fig. 3).

To empty the pulp container while you are juicing. Switch off the appliance and carefully remove the

pulp container.

Note: Reassemble the empty pulp container before you continue juicing.

4 Put the lter in the juice collector (1). Hold the lid over the lter and lower it into position

(2) (Fig. 4).

Make sure the lter is tted securely onto the driving shaft (‘click’)

Always check the lter before use. If you detect any cracks or damage, do not use the appliance

and contact the nearest Philips service centre or take the appliance to your dealer.

5 Snap the two clamps onto the lid to lock it into place (‘click’) (1). Align the groove in the

pusher with the small protrusion on the inside of the feeding tube and slide the pusher into

the feeding tube (2) (Fig. 5).

Make sure the clamps are locked into position on either side of the lid.

6 Place the juice jug under the spout (Fig. 6).

Place the lid on the juice jug to avoid splattering or if you want to store the juice in the refrigerator.



The appliance will only function if all parts have been properly assembled and the lid has been

properly locked in place with the clamps.

1 Wash the fruit and/or vegetables and cut them into pieces that t into the feeding tube. (Fig. 7)

2 Make sure the juice jug has been placed under the spout.

3 Turn the control knob to setting 1 (low speed ) or 2 (normal speed) to switch on the

appliance. (Fig. 8)

- Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes,

tomatoes, cucumbers and raspberries.

- Speed 2 is suitable for all kinds of fruits and vegetables.

4 Put the pre-cut pieces in the feeding tube and gently press them down towards the rotating

lter with the pusher (Fig. 9).

ENGLISH 7