Beko FFSG42012B — инструкция по замене инжекторов и настройке пламени для газовых устройств [18/96]

IFJJ FIame must be blue and have a regular shape jlf the flame is yellowish check if the burner s seated securely or clean the burner 1 Gas conversion DANGER Before starting any work on the gas installation disconnect the gas supply There is the risk of explosion In order to change your appliance s gas type change all injectors and make flame adjustment for all valves at reduced flow rate position Exchange of injector for the burners 1 Take off burner cap and burner body 2 Unscrew injectors by turning the counter clockwise 3 Fit new injectors 4 Check all connections for secure fitting and tightnessJ B New injectors have their position marked on their packing or injector table on Injector table page 13 can be referred to Varies depending on the product model On some hob burners the injector is covered with a metal piece This metal cover must be removed for injector replacement 1 Flame failure device model dependant 2 Sparkplug 3 Injector 4 Burner Unless there is an abnormal condition do not attempt to remove the gas burner taps You must call an Authorised service agent or technician with licence if it is necessary to change the taps Reduced gas flow rate setting for hob taps 1 Ignite the burner that is to be adjusted and turn the knob to the reduced position 2 Remove the knob from the gas tap 18 EN 3 Use an appropriately sized screwdriver to adjust the flow rate adjustment screw For LPG Butane Propane turn the screw clockwise For the natural gas you should turn the screw counter clockwiseonce The normal length of a straight flame in the reduced position should be 6 7 mm 4 If the flame is higher than the desired position turn the screw clockwise If it is smaller turn anticlockwise 5 For the last control bring the burner both to highflame and reduced positions and check whether the flame is on or off Depending on the type of gas tap used in your appliance the adjustment screw position may vary 1 Flow rate adjustment screw Reduced flow adjustment for the gas oven For the appropriate functioning of the oven re checking the by pass adjustment is extremely important In order to provide maximum security to the user these operations have to be done with care 1 Ignite the burner that is to be adjusted and turn the knob to the high flame position 2 Close the oven door and wait for 10 to 15 minutes until the oven becomes ready for adjustment 3 Take out the knob 4 After 15 minutes adjust the oven to the lowest flame position