P.I.T. PMIG205-С [8/35] Overloading is forbidden
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

P.I.T. PMIG205-С [8/35] Overloading is forbidden

P.I.T. PMIG165-С [8/35] Overloading is forbidden

Содержание

Похожие устройства

AUTOMATIC WELDING MACHINE SAFETY PRECAUTIONS environment 1 Welding must be carried out in a dry environment at a humidity of 90 or less 2 The temperature of the operating environment should be between 10 C and 40 C 3 Avoid outdoor welding if there is no protection from sunlight and rain Welding all places where there the time should be is no strong air dry do not put it on the wet ground or in puddles 4 Avoid welding in dusty places or places with corrosive chemical gas 5 Welding in a protective environment should be carried out in movement Ventilation This machine can create a powerful arc welding current with strict cooling requirements that cannot be provided by natural ventilation Therefore the built in fan is very important to enable the machine to operate stably with efficient cooling The operator must ensure that the cooling air baffles are open and not blocked Minimum distance between machine and surrounding objects should be 30 cm Good ventilation is critical for normal operation and service life of the machine Over voltage is forbidden For the supply voltage range of the machine refer to the Product specifications table This machine has automatic voltage compensation which allows you to maintain the voltage within the specified range If the input voltage exceeds the specified value it can damage the components of the machine _______________________________________________________ Overloading is forbidden Remember to observe the maximum load current at all times see the corresponding operating cycle Ensure that the arc welding current does not exceed the maximum load current Overloading is sure to shorten the machine service life or even damage it ________________________________________________________________________________________________ Overheating protection An abrupt halt can occur when the front panel overheating led is lit and the machine is in an overload condition Under these circumstances the machine docs not need to be restarted Continue operation of the built in fan to reduce the temperature inside the machine Welding can be continued when the internal temperature drops to the standard range and the overheating led goes out MAINTENANCE WARNING The folowing operation requires sufficient professional knowledge of electrics and a conprehenshc knowledge of safetv Operators must haw valid qualification certificates proving their skilh and knowledge Male sure the input cable of the machine is dsconnccted from the power source before opening the welding mac line I Check periodically whether the internal scheme connection is in good condition especially the plugs Tighten loose connections If corrosion is present remove it with abrasive paper and then reconnect 2 Keep your hands hair and tools away from moving parts such as the fan to avoid injury or damage to the machine 3 Periodically remove dust with dry and clean compressed air If the operating environment contains a lot of smoke and dirt the machine should be cleaned daily The compressed air pressure must be at the appropriate level to avoid damage to small parts inside the machine 4 Avoid getting rain water and vapors inside the machine If they get inside the machine dry it and check the machine insulation including the points between the connections and between the connection and the case The machine can be used only in the absence of abnormal phenomena 5 Check periodically whether the insulation of all cables is in good condition In case of any wear repair or replace 6 Check periodically whether the gas hoses is in good condition Replace it in the presence of any cracks 7 If the machine is not used for a long time store it in a dry place in the original packaging

Скачать