Microlife BP 3AC1-1 Инструкция по эксплуатации онлайн [13/66] 72590

Note:

If it is not possible to fit the cuff to the left arm, it can also be

placed on the right. However all measurements should be made

using the same arm.

5.4. Measurement mode selection

Clinical studies demonstrate taking multiple blood pressure readings and calculating an «average» is more

likely to determine your true blood pressure. This blood pressure monitor allows you to switch to the special

Microlife Average Mode – MAM – that automatically takes multiple readings!

MAM Mode:

a) If you would like to take a MAM measurement, please slide the

switch to the right toward no. 3.

b) MAM mode takes generally 3 measurements in succession and

calculates the result.

c) The « » symbol in the display indicates that the device is

set to the MAM mode.

Single mode:

a) If you would like to take a single measurement, please slide the

switch toward no. 1.

b) Single mode only has 1 measurement.

User selection:

With this advanced blood pressure monitor you can store

the individual measurements of two different people.

a) Before each measurement, make sure you program the

device for User 1 or User 2.

b) When the device is used for the first time, it always starts

with User 1. Push the User/Time button and hold the button

for about 3 seconds, until User 1 starts flashing.

Now select User 2 with the MEMORY button.

c) Now wait for about 3 seconds until User 2 stops

flashing. The device is now programmed for User 2.

d) Repeat this process to get back to User 1.

e) Microlife suggests that the first person who uses the

device is User 1.

5.5. Measuring procedure

After the cuff has been appropriately positioned, the measurement can begin:

a) Press the O/I button. The pump begins to inflate the cuff. The

rising pressure in the cuff is shown in the display.

b) After reaching the inflation pressure, the pump stops and the

pressure gradually falls. The cuff pressures are displayed.

TIME

START