Home
Главная
Microlife
Тонометры
BP 3BTO-AP
Инструкция по эксплуатации Страница: 12

Microlife BP 3BTO-AP Инструкция по эксплуатации онлайн [12/48] 72599

Error No. Possible cause(s)

ERR 1 The systolic pressure was determined but afterwards the cuff pressure fell below 20 mmHg.

The tube may have become unplugged after the systolic blood pressure was measured.

Further possible cause: No pulse could be detected

ERR 2 Unnatural pressure impulses impair the measurement result. Possible cause: The arm was

moved during the measurement (artefact).

ERR 3 Inflation of the cuff takes too long. The cuff is not correctly seated or the hose connection is

not sealed.

ERR 5 The measured readings indicated an unacceptable difference between systolic and diastolic

pressures. Take another reading following directions carefully. Contact you doctor if you

continue to get unusual readings.

HI The pressure in the cuff is too high (over 300 mmHg) or the pulse is too high (over 200 beats

per minute). Relax for 5 minutes and repeat the measurement.*

LO The pulse is too low (less than 40 beats per minute). Repeat the measurement.*

* Please consult your doctor, if this or any other problem occurs repeatedly.

Other possible malfunctions and possible solutions – If problems occur when using the device, the

following points should be checked and if necessary, the corresponding measures are to be taken:

Malfunction Remedy

The display remains empty when the

instrument is switched. Batteries have

been installed.

The pressure does not rise although the

pump is running.

The instrument frequently fails to measure

the blood pressure values, or the values

measured are too low (too high).

Every measurement produce different value

although the instrument functions normally

and the values displayed are normal

Blood pressure values measured differ from

those measured by the doctor.

☞ Further information

The level of blood-pressure is subject to fluctuations even in healthy people. It is important to compare

measurements taken under the same conditions and at the same time of day. (Quiet conditions)!

For licensing, this device has been subjected to strict clinical tests and supervised by experienced Cardiac

Specialists.

If you have any questions regarding the use of this blood pressure monitor, please ask your dealer or

pharmacist for the Microlife Service representative in your country. The Microlife Service Team will be

happy to help you. Never attempt to repair the instrument yourself!

Any unauthorized opening of the instrument invalidates all guarantee claims!

1. Check the polarity of the batteries (+/-)

2. If the display is erratic or unusual, remove the batteries

and re-install new batteries.

• Check the connection of the cuff tube and connect

properly if necessary.

1. Ensure the cuff fits correctly.

2. Make sure that the cuff is not fitted too tightly. Ensure

tight clothing such as a a rolled-up sleeve isn’t exerting

pressure on the arm above the measuring position. Take

off articles of clothing if necessary.

3. Measure blood pressure again in complete peace and quiet.

• Please read the following information and the points

listed under «Common sources of error». Repeat the

measurement.

• Record the daily development of the values and consult

your doctor.

Microlife BP 3BTO-AP Инструкция по эксплуатации онлайн [12/48] 72599

Содержание

Похожие устройства