Microlife BP 3AS1-2 Инструкция по эксплуатации онлайн [10/50] 72604

c) After the inflation process remain in a quiet and relaxed sitting

position. The measurement now proceeds on its own. If no

measurement takes place and all that appears in the display is

aflashing,upwardspointingarrow,seebelowunder«Inflate

further». When the instrument detects a pulse, a heart symbol in

the display starts to flash.

d) A longer beep sounds when the measurement has been com-

pleted. The systolic, and diastolic blood pressures and pulse rate

now appear in the display.

At the same time, the cuff pressure will be automatically re-

leased by the quick release valve of the device.

5.5. Inflating further

If the cuff is not inflated sufficiently, the measurement stops after

a few seconds and a flashing arrow pointing upwards appears in the

display. It is then necessary to inflate further to at least 20 mmHg

higher than the previous value. The instruction to inflate further can

appear several times if the pressure is still not sufficient.

Attention:

Ifthecuffisinflatedtoofar(over300mmHg),«HI»appearsinthe

display and a warning signal sounds. The cuff pressure must then be

immediately released by pressing the 0/I button.

As soon as the cuff is inflated sufficiently and the measurement is

proceeding, continue as described under points c-d.

5.6. Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for

any reason (e.g. the patient feels unwell), the O/I button can be

pressed at any time.

The device immediately lowers the cuff-pressure automatically.

5.7. Memory – displaying the last measurement

The measured results are stored in the instrument until

a new measurement is carried out or the batteries are

removed. You can call up the stored values at any time by

pressing the O/I button for at least 3 seconds.

6. Error messages/malfunctions

If an error occurs during a measurement, the measurement

is discontinued and a corresponding error code is displayed.

(Example Error no. 1)