Home
Главная
Microlife
Тонометры
BP 3AS1-2
Инструкция по эксплуатации Страница: 11

Microlife BP 3AS1-2 Инструкция по эксплуатации онлайн [11/50] 72604

* Please consult your doctor, if this or any other problem occurs repeatedly.

Other possible malfunctions and their elimination – If problems occur when using the device, the fol-

lowingpointsshouldbecheckedandifnecessary,thecorrespondingmeasuresaretobetaken:

☞ Further information

The level of blood-pressure is subject to fluctuations even with healthy people. Important thereby is, that

comparable measurements always require the same conditions (rest conditions)!

You must consult your specialist dealer or chemist if there are technical problems with the blood-pressure

instrument. Never attempt to repair the instrument yourself!

Any unauthorised opening of the instrument invalidates all guarantee claims!

Error No. Possible cause(s)

ERR 1

The systolic pressure was determined but after wards the cuff pressure fell below 20 mmHg.

This situation can occur, for example, if the tube becomes unplugged after the systolic blood

pressurehasbeenmeasured.Furtherpossiblecause:Nopulsehasbeendetected.

ERR 2

Unnaturalpressureimpulsesinfluencethemeasurementresult.Reason:Thearmwasmoved

during the measurement (Artefact).

ERR 5

The measured results have indicated an unacceptable difference between the systolic and

diastolic pressure. Take another measurement, carefully following the instructions. Contact

your doctor, if you still obtain unusual results.

The pressure in the cuff is too high (over 300 mmHg) OR the pulse is too high (over 200 beats

per minute). Relax for 5 minutes and repeat the measurement.*

The pulse is too low (less than 40 beats per minute). Repeat the measurement.*

Malfunction Remedy

The display remains empty when the instrument

is switched on although the batteries are in

place.

1. Check whether the batteries are installed with the

correct polarity and correct if necessary.

2. If the display is unusual, re-insert batteries or ex-

change them.

The pressure does not rise although the pump

is running.

•Checktheconnectionofthecufftubeandconnect

properly if necessary.

The device frequently fails to measure the blood

pressure values, or the values measured are too

low (too high).

1. Fit the cuff correctly on the arm.

2. Before starting the measurement make sure that

the cuff is not fitted too tightly and that there is no

rolled-up sleeve exerting pressure on the arm above

the measuring position. Take off articles of clothing if

necessary.

3. Measure the blood pressure again in complete peace

and quiet.

Every measurement results in different values

although the device functions normally and the

values are displayed.

•Pleasereadthefollowinginformationandthepoints

listedunder«Commonsourcesoferror».Repeatthe

measurement.

The blood pressure values measured differ from

those measured by the doctor.

•Recordthedailydevelopmentofthevaluesandcon-

sult your doctor about them.

Microlife BP 3AS1-2 Инструкция по эксплуатации онлайн [11/50] 72604

Содержание

Похожие устройства