Denzel ID-550 (26302) [8/28] Denzel
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Denzel ID-550 (26302) [8/28] Denzel

Denzel ID-550 (26302) [8/28] Denzel

Содержание

Похожие устройства

DEnZEL ELECTRIC IMPACT DRILL OPERATION 2 ATTENTION Always disconnect the power cable from the electrical outlet before preparing for the operation adjustment maintenance of power tools Installing the side handle 2 ATTENTION Always use the additional handle supplied with the machine Losing control of the machine can cause injury L ATTENTION Before work always check the reliability of the side handle Turn side handle 10 pic 1 counterclockwise relatively to securing collar by 2 3 turns to loosen it Install the sidehandleontheneckofthe machine body behind the chuck In this case the chuck 1 pic 1 is not an obstacle to the installation of the handle if necessary rotate the side handle another 1 2 turns Set the handle to a position that is convenient for operation and tighten the clamp by turning the handle clockwise Installation withdrawal of the working tool A ATTENTION When installing removing replacing the tooling disconnect the power plug Accidental switching on of the machine when changing accessories may cause significant injury Open the chuck by rotating its outer sleeve counterclockwise until the chuck s cams spread over a distance sufficient to install shank snap If the chuck is tightened use the key supplied with the machine Install shank snap into the chuck Use tooling with round or hex shank Never use a snap with an SDS plus shank designed for rotary hammers this shank cannot be centered properly in the three jaw chuck Close the chuck by turning the outer sleeve clockwise by hand Make sure the cams converge evenly and center the tool shank Tighten the chuck with the supplied key A ATTENTION In order to avoid damage to the engine of the machine and injury do not tighten or open the drill chuck turning on the engine while holding the outer sleeve of the chuck with the hand Main connection ATTENTION Power tools should only be connected to single phase AC power the voltage of which corresponds to the voltage indicated on the rating plate located on the tool housing If the rating plate indicates a voltage of 230V then the power tool can also be switched on to a main with a voltage of 220 V When working outdoors use industrial extension cords intended for outdoor use Do not use homemade extensions When working outdoors connect power tools to the power circuit equipped with a differential automatic with a response current of not more than 30 MA this will reduce the risk of electric shock When connecting ensure that the insulation of the electrical cable and the power plug of the machine is intact

Скачать