Daikin EHSX16P50BA [21/84] Remove cover hood and heat insulation

4 x Set-up and installation

Daikin Altherma EHS(X/H)

Daikin Altherma integrated solar unit

008.1441399_02 – 01/2021 – EN

Installation and operating instructions

● Install the Daikin Altherma EHS(X/H) at the installation site.

– Recommended clearances (fig. 4-5):

To the wall: (s1) ≥ 100 mm, (s2) ≥ 500 mm.

From the ceiling (X): ≥1200 mm, minimum 480 mm.

– Carefully transport the Daikin Altherma EHS(X/H), use the

handles.

– When setting up the unit in a cabinet, behind panels or in

other restricted conditions, sufficient ventilation

(e.g., using ventilation gratings) must be ensured.

● If necessary, install the optional Backup-Heater (EKBUxx)

into the Daikin Altherma EHS(X/H) (fig. 4-5).

Observe the assembly and operating manual supplied with

the accessory (

for tightening torque see chapter 10.3).

Fig. 4-5 Layout (shown on Daikin Altherma EHS(X/H) P50B with incor-

poration of the optional Backup-Heater)

4.3 Remove cover hood and heat insulation

● Lift the cover hood at the back and remove to the front.

Fig. 4-6 Removing the protective cover

Fig. 4-7 Daikin Altherma EHS(X/H) without cover hood

CAUTION!

The thermal insulation (fig. 4-7, item A)

consists of pressure sensitive shaped

EPP components that can easily be

damaged by inappropriate handling.

● Carry out removal of the thermal

insulation only in the sequence and in

the directions quoted below.

● Do not use force.

● Do not use tools.