Comet HB 500 HOTBOX 25/500 12В Инструкция по эксплуатации онлайн [24/76] 607776

Comet HB 500 HOTBOX 25/500 12В Инструкция по эксплуатации онлайн [24/76] 607776
24
people without supervision;
- hold the spray gun rmly during use: when operating the lever, the operator is subjected to the backlash
of the high-pressure jet; the power of this backlash is indicated in the table of technical specications
of the combined high-pressure cleaner (backlash power is expressed in N, where 1 N = 0.1 kg);
- do not direct the high-pressure jet against materials containing asbestos or other substances harmful
for the health;
- do not lock the lever on the spray gun in the always open position;
- do not cover the equipment and do not place it where ventilation is prevented (remember this above
all when using the equipment in closed environments);
- remember that when the combined high-pressure cleaner is in Total Stop it is to all eects operating;
consequently, the spray gun lever safety catch must be in lock position so it cannot be accidentally
started;
- do not leave the combined high-pressure cleaner in Total Stop without surveillance, not even for short
periods of time: in this case, always move the master switch of the combined high-pressure cleaner
and of the equipment to “0” position, remove the plugs from the socket and press the spray gun lever
to release any residual pressure;
- when not in operation, perform the operations described in the “STOP” section. In particular, disconnect
the combined high-pressure cleaner and the equipment from their power sources;
- operating pressure must never exceed the maximum value set for the equipment (see also
SPECIFICATIONS AND TECHNICAL DATA section);
- if a safety device cuts in repeatedly, do not use the equipment until it has been checked by a SKILLED
TECHNICIAN;
WARNING. High-pressure jets can be hazardous if incorrectly used. High-pressure jets must not be
directed against people, energized electrical appliances or the equipment itself.
If pipe ushing probes are used, insert the hose as far as the red sign before starting the equipment.
WARNING. This equipment has been designed to be used with the detergent supplied or recommended
by the Manufacturer. The use of other detergents or chemical products could aect safety.
WARNING. Explosion risk - Do not spray inammable liquids.
To protect the environment, vehicle engines and machinery with oil-pressure circuits must only be cleaned
in areas with a suitable oil trap.
Vehicles tyres must be cleaned at a distance of at least 50 cm/19 in to safeguard them from being damaged
by the high-pressure jet. The rst evidence of damage to a tyre is a change in its colour.
Do not use the equipment under the rain.
Do not remove the plug from the power socket by pulling the power cable.
Keep the power cable, any extensions, the plugs and the sockets dry. Do not touch with wet hands.
If the power cable is damaged, it must be replaced by the Manufacturer or by its technical assistance
service or in any case by a person with similar qualication, so as to prevent all risks.
Do not modify in any way the supply conditions of the equipment; in particular, do not modify the
fastening of the guards and the hydraulic connections; do not deactivate or tamper with the controls
and safety devices.
Keep clear of moving parts of the equipment, even if these are adequately protected.
Do not remove the guards from the moving parts.
Do not touch pipes containing liquids under pressure.
Inadequate optional accessories jeopardise equipment operation and could make it dangerous. Always
use only optional genuine accessories recommended by the Manufacturer.
Some accessories can have a maximum operating temperature that is lower than the maximum one that
the equipment may reach: in these cases it is therefore necessary to limit the temperature, by operating
on the relevant adjustment knob.
Carry out the steps described in the “STOP” section before handling or transporting the equipment.
The equipment must only be moved using the grip points provided on the handlebar. To lift use the
specic point indicated by the hook symbol.
When the equipment has to be transported, remember to anchor it rmly to the transport vehicle (using
ropes or other suitable methods). Engage the braking device, if tted.
When moving the equipment, take a rm hold of the handlebarto avoid that knocks and bumps caused
by unevenness of the ground make you lose your grip. Bear this in mind especially with a wet ground.
Do not move the equipment on gradients greater than 2% and when the ground is very wet.

Содержание

Скачать