Daikin EKHY075787 [2/4] Ekhy075787 ekps075867 ekps075877 ekps075917 ekps076197 ekps 076207 ekps076217 ekps076227

EKHY075787 / EKPS075867 / EKPS075877 / EKPS075917

EKPS076197 / EKPS 076207 / EKPS076217 / EKPS076227

Conversion Instructions

2 CONVERSION OF THE GAS RING

1. Switch off the electrical supply to the appliance

2. Close the gas tap on the gas supply to the appliance

3. Remove the front panel of the appliance

4. Disconnect the coupling above the gas valve and turn the gas mixing pipe backwards

5. Replace the original O-ring and the gas setting ring with the rings in the conversion set

6. Reconnect the coupling above the gas valve and open the gas tap

7. Check the gas connections for tightness/leaks

8. Switch on the electrical supply to the appliance

CAUTION

It is not possible to adjust the CO

level at high setting.

When the CO

level at high setting is not within the prescribed

tolerance band please contact your local Daikin or Rotex dealer.

For adjusting CO

level at low setting see § 3 .

9. Apply a sticker “gas type” (2 pcs. included in the conversion set) to the nut at the upper side of

the gas valve

10. Apply the second sticker “gas type” to the appliance plate (lower left corner) in such a way that

the original data referring to the gas type is covered.

11. Continue with checking the CO

setting of the boiler. See § 3 .

CAUTION

 Checking the CO

setting of the boiler must be executed with the

front panel removed.

 The maximum deviation of the flue gas analyser that is allowed is

± 0,3%.

 During the check the installation location must not be under the

influence of over- or under pressure situations.

 It is not possible to adjust the CO

value at maximum power..

 When the value measured at maximum power falls without the

prescribed range the boiler has to be checked on gas tightness and

usage of the correct components, in particular the gas ring, the

insert and the fan.

 When replacing parts that can affect combustion or conversion to

another gas type the CO

setting needs to be checked.