HAWK AQUA 1320R (1450 об/мин) — safety Guidelines for Operating Motor Pumps and Equipment [13/31]
Макгруп McGrp.ru

HAWK AQUA 1320R (1450 об/мин) — safety Guidelines for Operating Motor Pumps and Equipment [13/31]

Превью страниц Страница 13 / 31
HAWK AQUA 1320R (1450 об/мин) [13/31] Instructions manual
Instructions Manual
Motorpumps
Cod. doc. M.I. EP-18
Issue 0
Page 13 of 31
This Manual remains the property of the Manufacturer; it may not be reproduced or copied, even partially.
c) Electrocution:
On the motor that makes up the motorpump there are signs indicating the risk of electrocution if the protective covers are
opened. The manufacturer specifies that these covers must only be removed by qualified staff and only after disconnecting the
specific equipment from the power supply.
Please refer to the specific Use and Maintenance Manual of the main piece of
equipment.
3.3 Personal protective equipment
The operators using the equipment must wear the following personal protective equipment, in line with the work being carried
out:
Personal protective equipment against the risk of cuts, bruises and high temperatures (max 85 °C)
Work boots
Safety goggles or glasses (if necessary)
The Employer may decide to use additional safety equipment after assessing any risks and considering any changes made to the
production processes.
3.4 Working safely
To reduce the consequences of the hazards described in the section above, operators must comply with the following instructions:
Wear the personal protective equipment referred to in section 3.3;
Monitor areas where any hazard is present, do not start a test cycle if there are any persons located within the
hazardous area or in the immediate vicinity who are not involved in the job to be undertaken. Release the controls
immediately should any unauthorised persons enter the hazardous area when work is underway.
3.4.1 Safety when using the pump
The area and environment that the high pressure system operates in must be clearly signposted and prohibited to unauthorised
personnel. The area should also be restricted and defined. The staff responsible for carrying out the work must first undergo
workplace conduct training as well as training on the risks arising from high pressure system damages or defects. Prior to starting
up the system, the operator or operators are required to check:
that the system has the correct power supply;
that the electrical parts are correctly and adequately protected and work efficiently;
that the high pressure hoses and hose fittings do not exhibit signs of abrasion or excessive wear.
Any defect, damage or reasonable doubt that might arise before or during the operation must be reported and verified by qualified
staff. Should this happen, the system must be stopped immediately and the pressure brought down to zero.
3.4.2 Safety when using high pressure circuits
Here below are some basic indications regarding the high pressure circuit where the pump can be installed.
High pressure circuits should always be fitted with a safety or pressure relief valve.

Содержание

120

Похожие устройства

Ensure safe operation of motor pumps with essential guidelines on personal protective equipment, hazard monitoring, and safety protocols for operators. Stay safe while working.

Кешбек Менеджер