![Bomann GSPE 786 [7/34] For detailed operating method read the corresponding content on the instruction manual](/img/pdf.png)
Bomann GSPE 786 [7/34] For detailed operating method read the corresponding content on the instruction manual
![Bomann GSPE 786 [7/34] For detailed operating method read the corresponding content on the instruction manual](/views2/1081012/page7/bg7.png)
With each wash cycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rin se aid level
(Onmodelswithwatersoftenersystemonly.)
Electric indicator on control panel (if provided).
If there is no s alt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap. The machine will sta rt working after about 10 seconds.
Running the dish washer
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unload ing the dishwasher t o avoid handling
th e dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from t he lower b asket .
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. So ften re mnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Press the Programme button until the selected programme lights up.
( See the section entitled Operationg instruction )“”
When the working cycle has finished, the buzzer of the
dishwasherwillsound8times,thenstop.
Turn off the appliance using the ON/OFF button.
If the ap pliance is switched
off during a w ash cycle.
Open the door carefully.
Hot steam m ay esc ape
when the door is open ed!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
accordingtotheoriginalPower-onstate).
Switch on the appliance Press the On/Off button to switch on the appliance, Open the door.
1.Openthedooralittletostopthedishwasher.
2.After the spray arms stop working, you can open t he door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again after 10 seconds.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can only be modified if it has been running for a sho rt time. Otherwise the detergent
m ay have already been relea sed and the water a lready drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door a little to stop the washing, then press the Program button for more than 3 seconds to
c ancel the running programme.
3. Select a new prog ramme, then close th e door. The machine will restart after about 10 second s.
Содержание
- Attention before or after loading the dishwasher baskets 2
- B loading the salt into the softener 2
- Cutlery basket 2 2
- D function of detergent 2
- Dear customer 2
- Error codes 6 2
- Keep it to refer to it at a later date 2
- Pass it on to any subsequent owner of the appliance 2
- Please carefully read this manual before using the dishwasher it will help you to use and maintain the dishwasher properly 2
- The manufacturer following a policy of constant development and updating of the product may make modifications without giving prior notice 2
- This manual contains sections on safety instructions operating instructions installation instructions and troubleshooting tips etc 2
- This user manual shall also be got from the manufacturer or responsible vendor 2
- To review the section on troubleshooting tips will help you to solve some common problems by yourself 2
- Turning on the appliance 4 2
- Wash cycle table 3 2
- Dispose of the dishwasher packaging material correctly all packaging materials can be recycled plastic parts are marked with the standard international abbreviations pe for polyethylene e g sheet wrapping material ps for polystyrene e g padding material pom polyoxymethylene e g plastic clips pp polypropylene e g salt filler abs acrylonitrile butadiene styrene e g control panel 6
- For detailed operating method read the corresponding content on the instruction manual 7
- Adjusting salt consumption 9
- Before using your dishwasher for the first time 9
- Clark british degree 9
- Contact your local water board for information on the hardness of your water supply 9
- Dh 1 5 clarke 1 8 fh 0 78mmol l 1 9
- Dh german degree 9
- Fh french degree 9
- If your model does not have any water softener you may skip this section 9
- The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of the water used this is intended to optimise and customise the level o f salt consumption 9
- The water softener must be set manually using the water hardness dial the water softener is designed to remove minerals and salts from the water which would have a detrimental or adverse effect on the operation of the appliance the higher the content of these minerals and salts the harder your water is the softener should be adjusted according to the hardness of the water in your area your local water authority can advise you on the hardness of the water in your area 9
- Unscrew the cap from the salt container 2 there is a ring on the container with an arrow on it see figure on the side if necessary rotate the ring in the anticlockwise direction from the setting toward the sign based on the hardness of the water being used it is recommended that adjustments should be made in accordance with the following scheme 9
- Always use the salt intended for use with dishwasher the salt container is located beneath the lower basket and should be filled as explained in the following 10
- Attention 10
- Function of rinse aid 10
- Only use salt specifically designed for the use in dishwashers every other type of salt not specifically designed for the use in a dishwasher especially table salt will damage the water softener in case of damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is liable for any damages caused only fill with salt just before starting one of the complete washing programs this will prevent any grains of salt or salty water which may have been spilled remaining on the bottom of the machine for any period of time which may cause corrosion 10
- Rinse aid dispenser 10
- The salt container must only be refilled when the salt warning light in the control panel comes on depending on how well the salt dissolves the salt warning light may still be on even though the salt container is filled if there is no salt warning light in the control panel for some models you can estimate when to fill the salt into the softener by the cycles that the dishwasher has run 2 if there are spills of the salt a soak or a rapid program should be run to remove the excessive salt 10
- Adjusting rinse aid dispenser 11
- Detergents 11
- If there is no rinse aid warning light in the control panel you can estimate the amount from the colour of the optical level indicator c located next to the cap when the rinse aid container is full the whole indicator will be dark as the rinse aid diminishes the size of the dark dot decreases you should never let the rinse aid level fall 1 4 full 11
- Proper use of detergent 11
- When to refill the rinse aid dispenser 11
- Amount of detergent to use 12
- Concentrated detergent 12
- Detergent dispenser 12
- Detergent tablets 12
- Dishwasher detergent is corrosive take care to keep it out of reach of children 12
- Fill in detergent 13
- Are not suitable are of limited suitability 14
- Adjusting the upper basket 17
- Do not let any item extend through the bottom always load sharp utensils with the sharp point down 17
- Folding spikes of lower basket 17
- 1 0 16 18
- 1 2 12 18
- A shorter wash for lightly soiled loads and quick wash 18
- Capacity 12 setting position upper basket upper wheels on rails rinse aid setting 6 the power consumption of off mode is 0w left on mode is 0 w 18
- En 50242 this programme is the test cycle the information for comparability test in accordance with en 50242 as follows 18
- For heaviest soiled crockery and normally soiled pots pans dishes etc with dried on soiling 18
- For lightly soiled crockery and glass 18
- For lightly soiled load that do not need excellent drying efficiency 18
- For normally soiled loads such as pots glasses and lightly soiled pans 18
- G 30 0 0 11 18
- Means need to fill rinse into the rinse aid dispenser 18
- Or 3in1 18
- Rinse 50 drying 18
- This is standard programme it is suitable to clean normally soiled tableware and it is the most efficient programme in teams of its combined energy and water consumption for that type of tableware 18
- Wash 40 rinse 18
- A cycle that is underway can only be modified if it has only been running for a short time otherwise the detergent may have already been released and the appliance may have already drained the wash water if this is the case the detergent dispenser must be refilled see the section entitled loading the detergent open the door a little to stop the washing press the programme button more than 3 seconds to cancel the running programme then you can select other programmes see the section entitled starting a wash cycle when you select intensive normal eco programmes you can select the 3in1 function 19
- It is dangerous to open the door when washing because the hot water may scald you 19
- Open the door carefully 19
- Switch off the dishwasher 19
- Unloading the dishwasher 19
- Filter assembly 20
- Cleaning the door 21
- Cleaning the filter 21
- Cleaning the spray arms 21
- It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings to remove the spray arms screw off the nut clockwise to take out the washer on top of the spray arm and remove the arm wash the arms in soapy and warm water and use a soft brush to clean the jets replace them after rinsing them thoroughly 21
- Protect against freezing 21
- Remarks 21
- The entire filter assembly should be cleaned once a week 21
- When cleaning the filters don t knock on them otherwise the filters could be contorted and the performance of the dishwasher could be decreased 21
- After every wash 22
- If the appliance must be moved try to keep it in the vertical position if absolutely necessary it can be positioned on its back 22
- Installation preparation 22
- Moving the appliance 22
- No solvents or abrasive cleaning 22
- Remove the plug 22
- When not in use for a longtime 22
- Figure1 23
- Figure2 23
- Figure3 23
- The aesthetic wooden panel could be processed according to the figure 3 23
- Unit mm 23
- Figure4a 24
- Connection of drain hoses 25
- Figure5 25
- Figure6 25
- Tension adjustment of the door spring 25
- Dishwasher installation steps 26
- Figure 7 26
- Figure 8 27
- For personal safety do not use an extension cord or an adapter plug with this appliance do not under any circumstances cut or remove the earthing connection from the power cord 27
- A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher if your sink has one it is recommended that the hose be disconnected and the hole plugged 28
- Connect the cold water supply hose to a threaded 3 4 inch connector and make sure that it is fastened tightly in place if the water pipes are new or have not been used for an extended period of time let the water run to make sure that the water is clear and free of impurities if this precaution is not taken there is a risk that the water inlet can get blocked and damage the appliance 28
- Extension hose 28
- How to drain excess water from hoses 28
- Positioning the appliance 28
- Syphon connection 28
- The safety supply hose consists of the double walls the hose s system guarantees its intervention by blocking the flow of water in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full of water 28
- Water outlet 28
- Use only the special dishwasher detergent to avoid suds if this occurs open the dishwasher and let suds evaporate add 1 gallon of cold water to the tub close and latch the dishwasher then select any cycle dishwasher will drain out the water at the first step open the door after draining is stop and check if the suds is disappeared repeat if necessary 30
- If overflow occurs turn off the main water supply before calling a service if there is water in the base pan because of an overfill or small leak the water should be removed before restarting the dishwasher 31
- When some malfunctions come on the appliance will display error codes to warn you 31
- Technical data sheet 33
Похожие устройства
- Dell Latitude E5520 /L025520107L/ Инструкция по эксплуатации
- Dell Latitude E6410 /L106410116RR/ Инструкция по эксплуатации
- Bomann GSPE 874 Инструкция по эксплуатации
- Akai AM800-DS20 Инструкция по эксплуатации
- Dell Latitude E6320 /L026320104R/ Инструкция по эксплуатации
- Bomann GSPE 873 Инструкция по эксплуатации
- Akai ARF 201-380 Инструкция по эксплуатации
- Acer V275HL Abid Инструкция по эксплуатации
- Bomann GSPE 774.1 Инструкция по эксплуатации
- Akai ARF 186-340 Инструкция по эксплуатации
- Apple MD103A8GH3RS/A Инструкция по эксплуатации
- Bomann GSPE 773.1 Инструкция по эксплуатации
- Apple MD104AC1H5RS/A Инструкция по эксплуатации
- Bomann GSPE 772.1 Инструкция по эксплуатации
- Akai ARL 2522M Инструкция по эксплуатации
- Apple MD104AH4RS/A Инструкция по эксплуатации
- Bomann GSPE 771.1 Инструкция по эксплуатации
- Bosch GID 14A50 Инструкция по эксплуатации
- Apple MC97616GH1RS/A Инструкция по эксплуатации
- Hitachi DH28PD Инструкция по эксплуатации