Haier HWF12D1W1 [12/13] General information and tips
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Haier HWF12D1W1 [12/13] General information and tips

Haier HWF12D1W1 [12/13] General information and tips
2322

Troubleshooting Troubleshooting
In case of power failure
Troubleshooting without display code
Problem Cause Solution
Washing machine
fails to operate.
1. Power failure
2. Machine hasn’t been switched
on.
3. Door is not properly closed.
4. P
5. Child lock is activated.
5. Deactivate child lock.
rogramme is not yet started
1. Check power supply.
2. Switch the machine on.
3. Close the door p roperly.
4. Press “START/PAUSE”
button.
Washing machine
will not fill with
water.
1. No water
2. Inlet hose is kinked.
3. Inlet hose filter is blocked.
4. Water pressure is less than
0.03Mpa.
5. Door is not properly closed.
6. Water supply failure.
1. Check water tap.
2. Check in let hose.
3. Unblock inlet hose filter.
4. Check water pressure.
5. Close the door properly.
6. Ensure the water supply.
Machine is
draining while
being filled.
1. Height of d rain hose is bel ow
80cm.
2. Drain hose end could reach
into water.
1. Make sure that drain hose is
properly installed.
2. Make sure the drain hose is
not in water.
Drainage failure.
1. Drain hose is bloc ked.
2. Pump filter is blocked.
3. Drain hose end is higher than
100cm above floor level.

Problem Cause Solution
Strong vibration
while spinning.
1. Not all t ransportation bolts
have been removed.
2. Appliance has no solid
position.
3. Machine load is not correct.
1. Remove all transportation
bolts.
2. Ensure solid ground and
a levelled position.
3. Check load weight and
balance.
Operation stops
for a period of
time.
1. Appliance displays error code.
2. Problem due to load pattern.
1. Consider display codes.
2. Reduce or adjust load.
Operation stops
before completi-
ng wash cycle.
Water or electric failure.
Check power and water
supply.
Excessive foam
floats drum and/or
detergent drawer.
1. Detergent is not a appropriate.
2. Excessive use of detergent in
manually dosage.
1. Check detergent recom-
mendations.
2. Reduce amount of deter-
gent.
General information and tips:
If too much foam is visible during spin cycle, the motor will stop and drain
pump will activate for 90 seconds. If that elimin ation of foam fails up to 3
times, p rogramme ends without spinning.
1. Unblock drain hose.
Make sure that drain hose
is properly installed..
Clean pump filter. 2.
3.
Automatic adjust-
ment
Washing programme
This is normal and doesn‘t
of washing
duration will be adjusted. affect functionality.
Spinning fails
Unbalance of laundry.
Check machine load and
laundr
y and run a spinning
programme again.
time
The current programme and its setting will be saved.
When power supply is restored, operation will be
resumed.
If a power failure cuts an operating wash programme
door opening is mechanically blocked. To get out any
laundry water level should not be seen in the glassy
porthole of the door. - Danger of burns! Water level has
to be lowered as described in “Pump filter”. Not till then
pull lever (A) beneath service flap until door is unlocked
by a gentle click. Afterwards refix all parts.

Содержание

Похожие устройства

Скачать