DOD MyCam2 Инструкция по эксплуатации онлайн [12/76] 76571

4. To obtain the IP addresses specific to your network, click “Start” then “Run” and type “cmd” in the text box

and click “Ok”. The will bring up the MS-DOS prompt and in this window type “ipconfig/all” and press enter.

A screen similar to the one below will be displayed.

5. Take note of the following:

i) IP Address

ii) Subnet Mask

iii) Default Gateway

iv) DNS Servers (Both numbers with the first being the primary DNS server and the second being

the secondary DNS server)

6. Enter the details noted in step 5 into the relevant fields.

Note: The default IP address of the camera is 192.168.168.100This can be changed to any IP address on

your IP range. For example if the IP address of your PC is 192.198.1.52 then the IP address of your camera

should be unique and on the same subnet, i.e. 192.198.1.X where X is any number between 1 and 255

except 52. Ensure the IP address you chose is not the same as other network devices on your network as

this will result in conflict and may cause the device to not to work properly.

7. Once you’ve entered all the details click “Apply” then “Exit”.