Haier AS182ATAHA [10/18] Power source
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Haier AS182ATAHA [10/18] Power source

Haier AS182ATAHA [10/18] Power source

Содержание

Похожие устройства

Selection of Installation Placeon of Inst PARTS AND FUNCTIONS Inserting Dry Batteries 7 Remove the lid Gently press the part indicatig OPEN TWO R 03 dry batteries and slide the lid away from the controller 2 Insert the dry batteries Make sure the dry batteries are set in the right directions according to Use two new dry batteries of the same the diagram in the cavity brand and type 3 Attach the lid Remove the batteries from the controller 4 Verify by the indicators When the remote controller does not work when it is not used for a long period after If displays do not appear after a press on ON OFF switch set dry Outdoor unit Indoor unit replacement of new dry batteries remove the dry batteries and insert them batteries more once more than ON OFF 30 switch seconds in later several or times press without Place robust not causing vibration where the body can be supported sufficiently Place not affected by heat or steam generated in the vicinity where inlet and outlet of the unit are not disturbed Place possible to drain easily where piping can be connected with the outdoor unit Place where cold air can be spread in a room entirely Place nearby a power receptacle with enough space around Refer to drawings Place where the distance of more than 1 m from televisions radios wireless apparatuses and fluorescent lamps can be left In case of fixing the remote controller on a wall place where the indoor unit can receive signals when the fluorescent lamps in the room are lightened Place which is less affected by rain or direct sunlight and is sufficiently ventilated Place possible to bear the unit where vibration and noise are not increased Place where discharged wind and noise do not cause a nuisance to the neighbors Place where a distance marked is available as illustrated in the above figure Select places to avoid the rain or direct sunlight or sea wind as far as possibe Avoid the places where may produce or accumulate corrosive gas SO2 etc combustible gas thinner prtrol etc and oily fog and heavy vapor kitchen Reserve enough space for the ventilation of the unit Select places that facilitate maintrnance Do not install the conditioner on nonspecific metal frame such as the security net Those installed open to street shall not be lower than 2 5mm the battery inserted Power Source Handling the Wireless Remote Controller When operating point the signal sending head toward the remote signal receiver of the indoor unit Do not allow any obstacles between the signal sending Before inserting power plug into receptacle check the voltage without fail The power source is the same as the corresponded name plate Install an exclusive branch circuit of the power A receptacle shall be set up in a distance where the power cord can be reached Do not extend the cord by cutting it head and the signal receiver The signal receiver may not receive the signal in a room which has an electro lighting rapid start type fluorescent Selection of Pipe lamp an inverter type fluorescent lamp or a cordless phone When attaching the wireless remote controller to a wall or post make sure that the indoor unit receives the signals Handle the wireless remote controller with care Do not drop throw or wet the remote controller Do not attach the remote controller to a place where it is To this unit both liquit and gas pipes shall be insulated as they become low temperature in operation Use optional parts for piping sett or pipes covered with equivalemt insulation material exposed to direct sunlight or heat 8 25

Скачать