Haier HLTW600AXW [8/46] Installation instructions installation instructions

Содержание

INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS Location Requirements Installation Steps Minimum clearances for closet and alcove installations Sides 1 in 2 5cm Rear 6 in 15 2cm IMPORTANT These instructions should be retained for future reference Follow the followings STEP by STEP to ensure a successful installation Closet Front 2 in 5 1cm Top 11 in 27 9cm Gap between end of water valve and the wall Case 1 Assemble supply hose after installing Over 3 9 in 10cm Case 2 Assemble supply hose before installing Over 2 8 in 7cm If the washer and dryer are installed together the closet front must have at least a 72 in2 465 cm2 unobstructed air opening Your washer alone does not require a specific air opening STEP 1 Select a location Before you install the washer make sure the location Has a hard level surface without carpeting or flooring that may obstruct ventilation Is away from direct sunlight Has adequate ventilation Is not exposed to freezing temperatures temperature under 32 F or 0 C Is away from heat sources such as oil or gas Has enough space so that the washer doesn t rest on its power cord STEP 2 Connect the water hose The water supply hoses are not supplied with your washer and must be purchased separately Before installing the water supply hoses make sure there are rubber gaskets inside the fittings at both ends of each new water hose Installing the water supply hoses without rubber gaskets can cause water leakage When you initially install the washer be sure to use new hoses Failing to do so may result in a water leakage or overflow and may damage your property Do not connect multiple water supply hoses together to increase the length of the supply hose Hoses connected this way can leak and the leakage can cause electrical shock If a hose is too short replace the hose with a longer high pressure hose 1 Connect the ends of the water supply hoses to the HOT and COLD faucets 2 Tighten the fittings by hand until they are snug and then tighten them an additional two thirds of a turn with a wrench A A Recessed area B Side view closet or confned area When you fasten the fittings do not fasten them too tightly or apply tape or sealant to the faucets or water supply intakes This can damage the fittings After you have connected the water supply hoses to the faucets ensure that they are connected correctly by pulling the water supply hoses downwards 3 Place the unconnected ends of the hoses into a bucketand open the faucets connected to the two water supply hoses for 10 or 1 5 seconds to remove any foreign substances from the hoses Close the faucets before continuing 4 Connect the ends of the water supply hoses to the water supply intake connections at the back of the washer A The water supply hose connected to the HOT faucet must be connected to the hot water supply intake and the water hose connected to the COLD faucet must be connected to the cold water supply intake 5 Tighten the fittings by hand until they are snug and then tighten them an additional two thirds of a turn with a wrench A 13 Confirm that the water supply hoses are not twisted or bent If the hoses are twisted or bent the hoses can leak and cause electric shock due to the water leakage 14 Cold Hot

Скачать