Home
Главная
Brayer
Электрочайник
BR1015
Инструкция по эксплуатации Страница: 7

Brayer BR1015 [7/40] Using the electric kettle

• Install the lid (9), make sure that the kettle lid is closed

tightly.

Note: it is recommended to install the tea infuser (7) in the

lid (9) during the rst boiling of water.

• Place the kettle on the base (4).

• Insert the power cord plug into the mains socket, you

will hear a sound signal.

STANDBY MODE.

• The button «100°С» illumination will light up blue and

start ashing. Press the «ON/OFF» button (1), the

button (1) illumination will light up red and the boiling

will start.

• When the water starts boiling, you will hear sound

signals, the button «100°С» illumination will glow blue,

the «ON/OFF» button (1) illumination will glow green.

Note: after the water boiling the button illumination will go

out in 5 minutes.

• Remove the kettle from the base and carefully pour out

boiled water into a suitable bowl.

• Remember that there is boiling water inside the kettle

ask (5), always hold the kettle only by the handle (11),

do not tilt the kettle sharply, in case of careless use of

the kettle you can get burns by hot water.

• Repeat the water boiling procedure several times.

ATTENTION! To avoid burns by hot steam, do not bend

over the spout (8).

• Hot water resulting from the rst boilings is not

recommended to consume, you may use it for domestic

needs.

USING THE ELECTRIC KETTLE

• Place the kettle on a solid steady at and non-slip non-

metal surface away from heat sources as far as possible

from the edge of the surface.

WATER BOILING

• Take the handle (10), pull it upwards and remove the lid

(9).

• Fill the kettle with water not below the mark «MIN» and

not above the maximal mark «MAX» (6).

• Close the lid (9) and put the full kettle on the base (4).

Note: if you are not going to brew the tea directly in the

kettle ask (5), do not install the tea infuser (7) in the lid (9).

• Insert the power cord plug into the mains socket, you will

hear a sound signal, button «100°С» illumination will light

up blue and start ashing.

• Press the «ON/OFF» button (1), the «ON/OFF» button

(1) illumination will light up red and the boiling process

will start.

• When the water starts boiling, you will hear sound

signals, the button «100°С» illumination will glow blue,

the «ON/OFF» button (1) illumination will glow green.

• If it is necessary to switch the kettle o󰀨, press the On/O󰀨

button (1) «ON/OFF».

Brayer BR1015 [7/40] Using the electric kettle

Содержание

Похожие устройства