![Black & Decker FSM1630 [6/12] English](/img/pdf.png)
Black & Decker FSM1630 [6/12] English
![Black & Decker FSM1630 [6/12] English](/views2/1083425/page6/bg6.png)
6
ENGLISH
(Original instructions)
keep your cable out of the way of the work area.
u Always vacuum or sweep the oor before using the steam
mop.
u The easiest way to use the machine is to tilt the handle to
a 45˚ angle and clean slowly, covering a small area at a
time.
u Do not use chemical cleaners with your steam mop. To
remove stubborn stains from vinyl or linoleum oors, you
can use the steam burst button to apply extra steam to
the area or pre-treat with a mild detergent and some water
before using the steam mop.
Steam cleaning
u Place a cleaning pad (6 or 7) on the oor with the ‘hook &
loop’ side facing up.
u Raise the steam mop off the resting mat (8) and lightly
press it down onto the cleaning pad (6 or 7).
u Place the steam mop on the resting mat.
u Connect the steam mop to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Press the Autoselect
TM
button (2) till the required setting is
reached.
u Pulling the handle (4) back will activate the steam pump.
After a few seconds steam will start to come out of the
steam head.
Note: When rst lled or after running dry it can take up to 45
seconds for steam to be produced.
u It takes a few seconds for steam to enter the cleaning pad.
The steam mop will now glide easily over the surface to be
sanitised/cleaned.
u Push and pull the steam mop slowly across the oor to
thoroughly steam clean each section.
Note: During use you may turn off the steam pump by return-
ing the handle to the upright position, this convenient feature
will allow you to place the steam mop on the resting mat for
a short time so that you may move items of furniture, then
continue cleaning without the need to switch the appliance off.
u When you have nished using the steam mop, return the
handle (4) to the upright position and turn it ‘OFF’, place it
on the resting mat (8) and wait until the steam mop cools
down. (approximately ve minutes)
Caution! It is important to monitor the water level in the water
tank. To rell the water tank and continue to sanitise/clean,
return the handle (4) to the upright position and turn the steam
mop ‘OFF’. Unplug the unit from the electrical wall outlet,
remove and rell the water tank (3).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop on
the resting mat (8) with the handle (4) in the upright position
when stationary and make sure the steam mop is turned off
when not in use.
Carpet refreshing
u Place a cleaning pad (6) on the oor with the ‘hook & loop’
side facing up.
u Raise the steam mop off the resting mat (8) and lightly
press it down onto the cleaning pad (6).
u Place the carpet glider (9) on the oor.
u Lightly press the steam mop down onto the carpet glider
(9) until it clicks into place.
u Place the steam mop on the resting mat. (8)
u Connect the steam mop to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Press the Autoselect
TM
button (2) to the Wood/Laminate
setting.
u Pulling the handle (4) back will activate the steam pump.
After a few seconds steam will start to come out of the
steam head.
Note: When rst lled or after running dry it can take up to 45
seconds for steam to be produced.
u Push and pull the steam mop slowly across the carpet to
thoroughly refresh each section.
Note: During use you may turn off the steam pump by return-
ing the handle (4) to the upright position, this convenient
feature will allow you to place the steam mop on the resting
mat (8) so that you may move items of furniture with out the
need to switch the appliance off.
u When you have nished using the steam mop, return the
handle (4) to the upright position and turn it ‘OFF’, place it
on the resting mat (8) and wait until the steam mop cools
down. (approximately ve minutes)
Caution! It is important to monitor the water level in the water
tank. To rell the water tank and continue to sanitise/clean,
return the handle (4) to the upright position and turn the steam
mop ‘OFF’. Unplug the unit from the electrical wall outlet,
remove and rell the water tank (3).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop on
the resting mat (8) with the handle (4) in the upright position
when stationary and make sure the steam mop is turned off
when not in use.
After use (Fig. J & K)
u Return the handle (4) to the upright position and turn the
steam mop ‘OFF’,
u Place the steam mop on the resting mat (8) and wait until
the steam mop cools down. (approximately ve minutes)
u Unplug the steam mop from the electrical wall outlet.
u Empty the water tank (3).
u Remove the cleaning pad (6 or 7) and wash it ready for
Содержание
- Assembly 4
- Attaching a cleaning pad fig d 4
- Attaching the carpet glider fig g for use on carpets only 4
- Attaching the handle fig a 4
- Attaching the steam head fig b 4
- Attaching the water jug fig c 4
- English 4
- Features 4
- Filling the water tank fig f 4
- Intended use 4
- Removing a cleaning pad fig e 4
- Autoselec 5
- English 5
- Hints for optimum use 5
- Removing the carpet glider fig g 5
- Steam burst fig i 5
- Switching on and off 5
- Technology fig i 5
- The delta head fig h 5
- English 6
- Clip the supply cable onto itself using the cable tidy clip 22 close to the plug 7
- English 7
- If your appliance seems not to operate properly follow the instructions below if this does not solve the problem please contact your local black decker repair agent 7
- Next use take care to follow the wash care instructions printed on the cleaning pad 7
- Original instructions 7
- Place steam mop on the resting mat 8 for storage note with the handle 4 in the upright position the cable neatly wrapped around the cable tidy hooks 10 11 and secured with the cable tidy clip 22 your steam mop will stand on its own for storage alternatively there is a hanging bracket 23 built into the hand grip 24 which will allow your steam mop to be hung from a suitable hook on the wall always ensure that your wall hook is capable of supporting the weight of the steam mop safely 7
- Technical data 7
- Troubleshooting 7
- Wrap the supply cable around the cable tidy hooks 10 11 note the top cable tidy hook 11 rotates to easily release the cable ready for next use 7
- Fsm1630 8
- Do not forget to register your product 11
- English 11
Похожие устройства
- Mitsubishi Electric MSZ-FA35VA-E1 Инструкция по эксплуатации
- Samsung Galaxy S Duos La Fleur GT-S7562 Chiс White Инструкция по эксплуатации
- Mitsubishi Electric MSZ-FA25VA-E1 Инструкция по эксплуатации
- Black & Decker FSM1620 Инструкция по эксплуатации
- Samsung GALAXY ACE 2 La Fleur GT-I8160 White Инструкция по эксплуатации
- Mitsubishi Electric MUH-30RV-E1 Инструкция по эксплуатации
- Black & Decker FSM1610 Инструкция по эксплуатации
- Lenovo S720 Pink Инструкция по эксплуатации
- Mitsubishi Electric MSH-30RV-E1 Инструкция по эксплуатации
- Black & Decker ASI300 Инструкция по эксплуатации
- Lenovo S720 White Инструкция по эксплуатации
- Mitsubishi Electric MUH-24RV-E1 Инструкция по эксплуатации
- Black & Decker ASI500 Инструкция по эксплуатации
- Sony Xperia E Dual C1605 Black Инструкция по эксплуатации
- Mitsubishi Electric MUH-18RV-E2 Инструкция по эксплуатации
- Black & Decker ASI200 Инструкция по эксплуатации
- Draper Luma 127x169 MW white Инструкция по эксплуатации
- Mitsubishi Electric MUH-18RV-E1 Инструкция по эксплуатации
- Digma Cyber 1 Инструкция по эксплуатации
- Draper MicroScreen 61*81MW Инструкция по эксплуатации
Скачать
Случайные обсуждения
Ответы 0
Как пользоваться шваброй. Мы ее собрали а она не работает, воды налили и ни чего
9 лет назад