Festool CTL MIDI 583371 Инструкция по эксплуатации онлайн [12/62] 7721
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Festool CTL MIDI 583371 Инструкция по эксплуатации онлайн [12/62] 7721

Festool CTL MIDI 583371 Инструкция по эксплуатации онлайн [12/62] 7721
12
- Do not use to extract fl ammable or explo-
sive liquids (e.g. petrol, thinners). - Risk
of explosion!
- Do not use to extract aggressive liquids
(e.g. acids, alkalis, solvents)
- Remove plug from mains socket when not
in use and before maintenance work.
- Do not pull plug out of mains socket by
its cable.
- Protect the cable against heat, oil and
sharp edges.
- Do not leave devices out in the rain.
- Check the plugs and cables regularly and
have them replaced by an expert if dam-
aged.
- Do not lift or carry the devices by their
handles using a crane hook or lifting
gear.
- The device may only be used by persons
who have been trained in its use and who
are authorised to do so.
- If noxious dusts have been extracted, the
vacuum cleaner and all accessories must
be completely cleaned (inside and outside)
by suction and wiping, before removal
from the contaminated area.
Parts that cannot be completely cleaned
are to be packed for transport in a plastic
bag with an airtight seal.
- For safety reasons, only operate the ma-
chine using a totally earthed socket.
3 Appliance preparation and initial
operation
3.1 Electrical connection
The operating voltage shown on the
rating plate must correspond to the
voltage of the mains power supply.
Make sure that the vacuum cleaner
is switched off when you plug thep-
ower cable in.
3.2 On/off switch (1.1)
In position 0 the vacuum cleaner is switched
off and the appliance plug socket (1.3) is
dead.
Two modes of operation are possible:
a) Switch position „MAN“
The appliance plug socket is live.
Before turning the switch to the
„MAN“ position, ensure that the tool
connec-ted to the appliance plug
socket is switched off.
The cleaner motor starts immediately.
b) Switch position „Auto“
The appliance plug socket is live. Be-
fore turning the switch to the „Auto“
position, ensure that the tool con-
nected to the appliance plug socket
is switched off.
The cleaner motor starts only when the tool
connected to the appliance plug socket is
switched on.
3.3 Suction force regulator (1.2)
The suction force regulator can be used to
vary the suction capacity. This permits a
precise adaptation to different substances
to be picked up.
3.4 Connecting an electric tool
Observe the maximum connected load on
the appliance plug socket (see “Technical
Data“)! Connect the electric tool to the ap-
pliance plug socket (1.3).
Make sure that the electric tool is
switched off when plugging it in and
unplugging it.
4 Operation
4.1 Changing the fi lter
During the following procedure, take care
not to raise dust more than is unavoid-
able.
Wear a P2 breathing protection mask
with health-hazardous dusts!
a) Changing the fi lter bag
Order No.:
CTL MINI 456772, CTL MIDI 494105
- Open locking clips (1.4), remove top sec-
tion (1.5),
- Change fi lter bag (2.1)–see print on fi lter
bag,
- Replace top section, close locking clips.
Note: A replacement fi lter bag can be
stored in the storage compartment (5.4).

Содержание

Похожие устройства

Скачать