Grundig GIEV613420E [12/96] Installation and connection

Содержание

Installation and connection The product must be installed in accordance with all local gas and electrical regulations Do not install the hob on places with sharp edges or corners There is the risk of breakage to the glass ceramic surface Electrical connection Connect the product to a grounded outlet line protected by a miniature circuit breaker of suitable capacity as stated in the Technical specifications table Have the grounding installation made by a qualified electrician while using the product with or without a transformer Our company shall not be liable for any damages that will arise due to using the product without a grounding installation in accordance with the local regulations The product must be connected to the mains supply only by an authorised and qualified person The product s warranty period starts only after correct installation Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons A The power cable must not be clamped bent or trapped or come into contact with hot parts of the product A damaged power cable must be replaced by a qualified electrician Otherwise there is risk of electric shock short circuit or fire Connection must comply with national regulations The mains supply data must correspond to the data specified on 12 EN the type label of the product Type label is at the rear housing of the product Power cable of your product must comply with the values in Technical specifications table Before starting any work on the electrical installation disconnect the product from the mains supply There is the risk of electric shock Connecting the power cable While performing the wiring you must apply with the national local electrical regulations and must use the appropriate socket outlet line and plug for oven In case of the product s power limits are out of current carrying capability of plug and socket outlet line the product must be connected through fixed electrical installation directly without using plug and socket outlet line 1 If it is not possible to disconnect all poles in the supply power a disconnection unit with at least 3 mm contact clearance fuses line safety switches contactors must be connected and all the poles of this disconnection unit must be adjacent to not above the product in accordance with IEE directives Failure to obey this instruction may cause operational problems and invalidate the product warranty Additional protection by a residual current circuit breaker is recommended