Unit UBS-2200 Light Grey [9/24] Measurement errors

SCALES | UBS-2200

ENGLISH

orie recommendation. Then the scales will show these results 5 times and

automatically shut down.

During the determination of your body fat percentage you will see an analysis of

the measurement results in the form of series of vertical symbols. This is given

for indication of your Fat percentage level, telling where your fat level standing is

comparing to the statistics norms. Whether you are considered as underweight,

normal, or overweight. You can take this indication as a reference data of your

condition.

NOTE: Each time you press the «SET» button you can start the measurement again (including changing

the settings of the previous user) in accordance with the above points.

WEIGHT MEASUREMENT

5. To activate the scales click on the segment of the working surface. After a

few seconds the value «0,0 kg» will appear.

6. Stand on the working surface gently (do not jump on the scales). As son as

you step on the scales there will be the weight indicator on the display (ﬁrst

time it will be increasing until it ﬁxes on the exact value). After a few sec-

onds the scales automatically turns off.

MEASUREMENT ERRORS

If there are errors during operation the display shows «Err». In this case wait

until the scales is turned off to start the measurement again, whether look if the

batteries are installed correctly. The list of possible defects is given below:

1. All symbols are lit at the same time. This happens when the scales are

switched on and indicates that the device is in good working order.

2. Err – : the maximum load of the scales has been exceeded.

3. Lo – : the battery is re-energize. Install new batteries.

4. Errh – : the maximum possible for these scales body fat content is exceeded.

5. Errl – : the body fat content is too low.

6. [ – : leave the scales and wait a few seconds. Repeat the weighing again.