Denzel VS-90-187 — руководство по использованию шлифовальной машины [10/28]

DEHZEL FINISHING SANDER Before getting started you must inspect the tool and make sure it is complete and there is no external damage make sure that the power switch is working correctly after transportation in winter conditions before switching on keep the machine at room temperature until the condensate is completely dry Getting started you must attach dust collector 3 pic 1 pic 2 make sure that the power switch 10 pic 1 4 pic 2 is in the position OFF then connect the machine to thepower supply test the machine at idle also after the replacement of the sanding sheet To turn the machine on it is necessary to turn the power switch 10 pic 1 4 pic 2 to the on position To turn the machine off turn the power switch 10 pic 1 4 pic 2 to the Off position While working after turning on the engine let the machine develop the set speed of the tooling and only after that you enter the tooling and the workpiece into contact clean the dust collector regularly Accumulated dust does not only increase the load on the engine of the machine but also reduces the efficiency and quality of processing always use the machine only for the types of work for which it is intended When processing wood metal and other materials use only equipment designed for this material safety of use of which at the sanding machine is no doubt do not allow mechanical damage shock falling of the tool on hard surfaces etc protect the machine from exposure to intense heat sources or chemically active substances as well as from the ingress of liquids and foreign solid objects inside the machine do not block or obstruct the ventilation openings in the machine housing turn the machine off using the switch before connecting I disconnecting from the power supply monitor the condition of the tooling and the heating of the electric motor At the end of the work disconnect the tool from the power supply making sure the switch is in the off position clean the machine and dust collector from dirt and dust A ATTENTION Do not leave dust in the dust collector for a long period Some types of dust can spontaneously ignite which is dangerous due to fire Recommendations for use Before you start processing a part you must fix it especially if it has a light weight Holding the tool firmly by the handle gently press down the sander to the work surface so that the sanding sheet touches it evenly over the entire area Do not exert excessive pressure on the tool during sanding because this can cause motor overload reduces the life of the sanding sheet and reduces the effectiveness of sanding During work periodically lift the machine over the work surface to remove dust and sludge from the surface of the part and abrasive sheet Do not overheat external machine parts during long work If there is an excessive heat stop working let the tool work without load for 1 2 minutes for engine cooling turn the engine off and take a break until the gear housing becomes cool Do not allow the machine work when there is extraneous or uncharacteristic noise in the engine or gear When there are noises turn off the tool and contact an authorized service