Makita Перфоратор HR4501C +Отвертка аккумуляторная 6723DW [6/12] Indicator lamp

CAUTION:

• Do not rotate the change lever when the tool is

running under load. The tool will be damaged.

• To avoid rapid wear on the mode change

mechanism, be sure that the change lever is

always positively located in one of the two or three

action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque

level is reached. The motor will disengage from the

output shaft. When this happens, the bit will stop turning.

CAUTION:

• As soon as the torque limiter actuates, switch off

the tool immediately. This will help prevent

premature wear of the tool.

Indicator lamp

006314

The green power-ON indicator lamp lights up when the

tool is plugged. If the indicator lamp does not light up,

the mains cord or the controller may be defective. The

indicator lamp is lit but the tool does not start even if the

tool is switched on, the carbon brushes may be worn out,

or the controller, the motor or the ON/OFF switch may be

defective.

The red service indicator lamp lights up when the carbon

brushes are nearly worn out to indicate that the tool

needs servicing. After approx. 8 hours of use, the motor

will automatically be shut off.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Side handle

003139

CAUTION:

• Use the side handle only when chipping, scaling or

demolishing. Do not use it when drilling in concrete,

masonry, etc. The tool cannot be held properly with

this side handle when drilling.

The side handle can be swung 360° on the vertical and

secured at any desired position. It also secures at eight

different positions back and forth on the horizontal. Just

loosen the clamp nut to swing the side handle to a

desired position. Then tighten the clamp nut securely.

006315

Side grip

006316

CAUTION:

• Always use the side grip to ensure operating safety

when drilling in concrete, masonry, etc.

The side grip swings around to either side, allowing easy

handling of the tool in any position. Loosen the side grip

by turning it counterclockwise, swing it to the desired

position and then tighten it by turning clockwise.

1. Side grip

1. Side handle

2. Clamp nut

1. Power-ON

indicator lamp

(green)

2. Service indicator

lamp (red)

Makita Перфоратор HR4501C +Отвертка аккумуляторная 6723DW [6/12] Indicator lamp

Содержание

Похожие устройства