Sinbo SHC-4353 Инструкция по эксплуатации онлайн [10/51] 83967

- 9 -

7. Ensure the hair is dry. Hair clippers perform best with dry hair, making it easier to see how

much hair is being cut.

TO ATTACH TRIMMING GUIDES

1. Select an appropriate length trimming guide to match the desired length of hair to remain

after the cut. The trimming guides are numbered and marked with 3mm, 6mm, 9mm, 12mm

2. Hold comb with teeth up, slide the attachment firmly onto

the bottom clipper blade.

FOR UNIFORM CUTTING

Allow the clipper to cut through the hair without forcing it at a faster rate, as this may create

a pulling sensation.

Use short strokes when cutting and initially use the longest trimming guide. You can always

use a closer trimming guide later if you want a closer cut.

HOW TO GIVE A HAIRCUT

1. Start at the back of the head. Holding the clipper as shown, lightly stroke

upwards making sure you are taking off the desired amount of hair. Work your

way up to the crown of the head in layers. When completed, comb the area to

remove any loose hair and determine if you need any further cutting.

2. Repeat the same procedure for each side of the head. Make sure the length

of the hair is trimmed the same on both sides of the head.

3. To cut the top of the head, hold the hair between your fingers and cut a small

amount at a time. Cut from the front to the back.

4. To trim around the ears and short hairs at the nape of the neck, you must

remove the trimming guide. Angle the clipper and lightly stoke around each

ear to the back of the neck. Be careful not to touch ears or to press too hard.

5. Final trim can be made with the hair clipper or the scissors. Make sure to

check over the entire head for any uneven areas. For styled hair or giving quick

trims, you may prefer using your hair clipper without the trimming guide.

6. The adjustable taper level allows you to gradually change the closeness of

the cut, either with or without a trimming guide. When the lever is fully forward

the blades will give the closest cut. Moving the lever gradually backwards

increases the cutting length.

SHORT TAPERED STYLES - "FLAT TOPS" & SHORT CUTS

1. Starting with the longest attachment comb (25mm), cut from the back of the neck to the

crown. Hold the attachment comb flat against the head and slowly move the clipper through

the hair, as shown.

2. Use the same procedure from the lower side to the upper side of the head,

as illustrated. Then cut the hair against the direction In which it grows and level

with the sides.

3. To give a "flat top" look, the hair on top of the head must be cut over the top

of a flat comb.

4. Use closer cutting attachment combs to taper the hair down to the neckline as desired.