Zotek ZT-98 Инструкция по эксплуатации онлайн
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Zotek ZT-98 Инструкция по эксплуатации онлайн

Zotek ZT-A6 Инструкция по эксплуатации онлайн
Push
this button over 2 seconds to turn on or
turn
off
the product.
The
product will automatically turn off after
15
minutes
of inactivity and the built-in beeper
beeps
5
times in 1 minute before auto power off.
To
cancel auto power off, push
HOLD/REL
button
before turning on the product, after
5
beeps
to cancel the auto power off successfully.
Push once
to hold the current reading on the
display in non
-capacitive mode ; push once to
clear data in the capacitive mode; p
ush for more
than 2 seconds to turn on the backlight.
And
long
-push again to turn off.
Press this button
to enter auto mode.
A
utomatically
switch to enter other functions
include temperature ,frequency ,AC/DC
voltage , resistance and continuity.
Short
press this button to automatically switch to
test diode/
continuity,capacitance and NCV.
Press
this button to enter current test
mode. It can automatically switch to test
AC and DC current.
In AC
voltage mode, it can identify
frequency
Automatically.
Press
to test temperature.
- 3 -
- 4 -
- 2 -
Measurements
Measure DC/AC Voltage (＞0.8V)
1. Only when the voltage is higher than 0.8V, this product
will show the display;
2. The DC or AC voltage will be auto matched;
3. Touch the probes to the correct test points of the circuit
to measure the voltage;
4. Read the measured voltage on the display.
Test for Current
1. Press the current button to enter current test mode;
2. Touch the probes to the correct test points of the circuit
to measure the current;
3. Read the measured current on the display.
Measure Resistance
1. The resistance measure will be auto matched;
2. Touch the probes to the desired test points of the circuit
to measure the resistance;
3. Read the measured resistance on the display.
Test for frequency
1. In AC mode, press Hz button to enter frequency test
mode.
2. Touch the probes to the desired test points of the circuit
to measure the frequency.
3. Read the measured frequency value on the display.
User Manual
All rights reserved.
Specifications are subject to change without notice.
Introduction
This product is a battery-powered, auto-ranging,
true RMS digital multimeter with a 6000 counts
LCD display.
Safety Information
To avoid possible electrical shock, fire, or
personal injury, please read all safety information
before you use the product. Please use the
product only as specified, or the protection
supplied by the product can be compromised.
• Examine the case before you use the product.
Look for cracks or missing plastic. Carefully
look at the insulation around the terminals.
• The measurement must be made within the
allowable measuring range.
• Do not use the product around explosive gas,
vapor, or in damp or wet environments.
• When the voltage to be measured exceeds
36V DC or 25V AC, the operator shall be
careful enough to avoid electric shock.
• Misuse of mode or range can lead to hazards,
be cautious. “OL” will be shown on the display
when the input is out of range.
• Low level of a battery will result in incorrect
readings. Change the batteries when battery
level is low. Do not make measurements when
the battery door is not properly placed.
Instruction Buttons
Measure Temperature
1. Press to enter in temperature test mode;
2. Touch the probes to the desired test points.
3. Read the measured temperature on the display.

Содержание

Похожие устройства

Скачать