Comprag WOS-5 [8/44] Version 2

Version 2.0

10. Welding or other similar operations must not be carried out in the immediate vicinity of the

equipment and vessels under pressure.

11. If there is any suspicion of overheating, combustion or other emergency, turn off the equipment.

Immediately disconnect it from the power supply. Do not open the doors of equipment until

the temperature falls to room temperature, in order to prevent burns or injury.

12. Naked ames must not be used as a light source for inspecting and checking equipment.

13. Never use caustic solvents, which may damage materials of the pneumatic system

14. After performing installation or other work, ensure that no instruments, rags or spare parts

have been left inside the equipment.

15. Pay particular attention to the safety-relief valves. Thoroughly inspect them and remove

any dust and dirt. They must not be allowed to suffer any loss in function under any circum- stances.

Remember that your safety depends on their functionality!

16. Before beginning work in normal mode after maintenance or repair work, check that the

working pressure, temperature and other characteristics are correctly set. Ensure that all

control devices are installed and functioning properly.

17. When replacing lters, separators etc., wipe away dust, dirt and oil residue from the area

where they are installed with a dry cloth.

18. Protect the motor, air lter, electrical components and control components etc. from com-

ing into contact with condensate. For instance, blow down with dry air.

19. Use protective gloves during installation and repair work in order to avoid burns and injury

(for instance, during oil change).