Philips SRU5150 [11/80] Replacing the batteries

5. Replacing the batteries

When the battery status indicator ( ) on the display starts blinking, battery power is

low and you should replace the batteries. All user settings will be retained when the old

batteries are removed.

1 Press the cover inward, slide it in the direction of the

arrow and remove the cover.

2 Insert 3 AAA/R03 batteries noting the + and -

configuration inside the battery compartment.

3 Place the cover back and click it firmly into place.

6. Support

Troubleshooting

• Problem

– Possible cause / solution

• The device you want to operate does not respond at all when a key is pressed.

– Point the remote control at the device and make sure that there are no obstructions

between the remote control and the device.

– Make sure the function you wish to operate is available on the device.

– Check if the battery status indicator ()on the display blinks (low battery power).

If this is the case, insert new batteries.

• The device you want to operate does not respond properly when a key is pressed.

– Maybe the wrong code is programmed for the device during setup.

Try setting up the remote again. If the device still does not respond, call our helpline.

– Check if the battery status indicator ()on the display blinks (low battery power).

If this is the case, insert new batteries.

• The teletext keys do not work.

– Find out whether your TV is equipped with teletext.

• You have difficulties operating all of the functions on your device.

– Maybe the remote control has to be adapted to the model of the device.

Call our helpline for details.

• ERROR appears on the display while adding an extra (advanced) function or when

trying to learn a key.

– No signal from the original remote control is received for 20 seconds and the SRU 5150

stopped the adding / learning process. Start again from step 1.

– An SRU 5150 key is pressed before a signal is detected and the SRU 5150 stopped the

adding/learning process. Start again from step 1.

– The function you try to add is not available on the original remote control.

– Make sure the original remote control is working properly.

– Make sure the remote controls are properly aligned.

– The IR signal of your original device is out of range.The SRU 5150 can only learn IR signals

with a carrier signal of 30-60kHz.

English

Instructions for use

Manual_SRU5150_87 24-04-2007 15:47 Pagina 11