Sencor SMR 600 Инструкция по эксплуатации онлайн [3/9] 87343

d Place the units in the charge cradle in an upright position The Charge LED indicators will light up e It takes about 10 hours to fully recharge the batteries if they are completely run down New batteries take up to 14 hours to fully charge Important Always turn off the PMR units when charging This will shorten the charging time Main socket f Charging the battery batteries using adaptor Lift the charge socket cover located on the right side of the handset Charge jack Mic spk jack Insert the round connector of the 9 0V DC 300mA adaptor into the charge jack Plug the mains adaptor into a 240V AC 50Hz main socket with the switch on the socket set to OFF Use only power supplies listed in the user instruction AC Adaptor Model TEE 090P030 Then switch ON the main socket Battery meter The battery meter is located in the left corner of the LCD Screen It appears like a battery with three bars inside These indicate the amount of power available When the battery level reaches it minimum level in PMR on mode unit will emit two beep tones and automatically the unit will power off The SMIR 600 can detect the battery charge in 4 levels Battery charge at high level Battery charge at medium level Battery charge at low level At this level the SMR 600 will emit a beep sound for every 10 seconds in normal mode Important Charge the unit for 10 14 hours Battery charge at very low level When the battery level reach it minimum level unit will emit two beep tone and automatically turn off the power and proceeds to watch mode mportant Charge the unit for 10 14 hours CAUTION Risk of explosion if battery is replaced by an incorrect type Disposed of used batteries according to the instructions Battery life The SMR 600 has a built in power saver to make the batteries last longer But when you are not using the units turn them OFF to conserve battery power 3 Operation

Скачать
Случайные обсуждения

Ответы 0

Как наступить чистоту
2 года назад

Ответы 0

Як пролити рацию
3 года назад