Home
Главная
Harman/Kardon
Ресиверы И Усилители
HK 3380
Инструкция по эксплуатации Страница: 14

Harman/Kardon HK 3380 [14/20] Operation

14 OPERATION

OPERATION

Basic Operation

Once you have completed the setup and configuration of

your new receiver, it is simple to operate and enjoy.

The

following instructions will provide the steps needed

enjoy the HK 3380:

• Install the two supplied AAA batteries in the remote

as shown. Be certain to observe the (+) and (–)

polarity indicators shown in the bottom of the

battery compartment.

•You may begin a listening session by pressing the

System Power Control 1 on the front panel or the

Main Power On Button å on the remote.The

Power Indicator 2 will turn red, then blue.This will

turn the unit on and return it to the input source that

was last used.The unit may also be turned on from

Standby by pressing any of the

Source Selector

buttons on the front panel 68)!#$

or remote ç.

To turn the unit off at the end of a listening session,

simply press the

System Power Control 1 on the

front panel or the

Main Power Off Button ∫ on the

remote.This places the unit in the Standby mode, and

the

Power Indicator 2 will turn amber to remind

you that the unit is ready for operation when a power

command is received from the remote.

When the remote is used to turn the unit “off” it is

actually placing the system in a Standby mode, as

indicated by the amber color of the

Power

Indicator

•To dim the brightness of the

Information Display

Û,press the Dimmer Button ^˙.The first

press will dim the lights to half normal.The

Power

Indicator

2 will remain lit, but the light inside the

Volume Control Ú will go out. A second press will

turn the display completely off, but the

Power

Indicator

2 will remain lit to remind you that the

unit is on. Press the

Dimmer Button ^˙ again

to restore the display to normal brightness.

Source Selection

•To select a source at any time, press any of the

Source Selector buttons on the remote ç or

front panel

68)!#$.

• When a video source is selected, if you have

connected a video device to the video input jack for

that source,and if you have connected the

Video

Monitor Output

· to the composite video input of

your TV or video display, you will be able to enjoy

video programs from a broadcast, cable or satellite

television system; a VCR or hard-disk video recorder;

a DVD player; or any other video device with analog

line-level audio outputs and a composite video output.

NOTE: Although the HK 3380 is an audio/video

receiver, it is not a surround sound receiver.Audio will be

played in two-channel stereo or monaural, depending on

how the program material is encoded, and you will not

be able to hear any additional channels that may be

encoded in your source materials.You will not be able

to make any digital audio connections through the

HK 3380.The HK 3380 is designed to provide video

entertainment in a small system application that includes

devices such as a TV,VCR or DVD player located in a

bedroom, office or spare room, or as part of a multiroom

system when used with a multiroom controller.

• During a listening session you may wish to adjust the

Bass Ó, Treble Ô and Balance Ò controls to

suit your listening tastes.

• Adjust the volume to a comfortable level using the

front-panel

Volume Control Ú or remote Master

Volume Up/Down

π buttons.The volume level is

displayed as a negative number of decibels (dB) in the

Main Information Display B.The volume level is

relative to a maximum volume level that has been

assigned the value of 0dB. It is important that you

make sure never to exceed this maximum volume

level (0dB) at any time,in order to avoid possible

damage to your loudspeakers due to “clipping”, a type

of distortion that is not audible to the human ear until

it is severe enough to permanently damage most

loudspeakers.It is also possible, depending upon the

program material, for clipping to occur at volumes

below the maximum volume level.

•To temporarily silence all speaker outputs, press the

Mute Button ®4.This will cut the output to all

speakers,but it will not affect any recording or dub-

bing that may be in progress.When the system is

muted, the

Mute Indicator K will flash in the

Information Display Û and MUTE will flash in

the

Main Information Display B.Press the Mute

Button

®4 again to return to normal operation.

•For private listening, plug the 1/4" stereo phone plug

from a pair of stereo headphones into the front-panel

Headphone Jack 3.

• One or two separate sets of speakers may be

connected to the HK 3380.To listen to one of

the speaker sets, press the

Speaker Selectors

57√∑ corresponding to the desired speakers.

The active speakers will be indicated by the

Speaker

Indicators

A.Both speakers may be turned off for

private headphone listening.

•To program the HK 3380 for automatic turnoff, press

the

will increase the time before shutdown, displayed by

the

Sleep Timer C, in the following sequence:

The sleep time will be displayed in the

Information

Display

Û and it will count down until the time

has elapsed.

When the programmed time has elapsed, the unit will

automatically turn off.The

Information Display Û will

dim to one-half brightness when the Sleep function is

programmed.To cancel the Sleep function, press the

bers disappear and the

Information Display Û shows

the current source.Pressing any control button while the

Sleep control is activated will momentarily return the

Information Display Û to full brightness for increased

legibility without interrupting the Sleep function.

Tuner Operation

The HK 3380’s tuner is capable of tuning AM,FM and

FM Stereo broadcast stations.Stations may be tuned

manually, or they may be stored as favorite station

presets and recalled from a 30-position memory.

Station Selection

1. Press the FM/AM Selector &ç to select the

tuner as an input.

2. Press these buttons again at any time to switch

between AM and FM.

3. To select stations, press the

Tuning Button 9Ü to

advance one frequency increment at a time,or press

and hold it, and the tuner will search for the next highest-

or lowest-frequency station that has an acceptable sig-

nal.To tune to the next station, press and hold the button

again.When the

Tuned Indicator I lights,the station

is properly tuned and should be heard with clarity.

4. Stations may also be tuned directly by pressing the

Direct Button ∆,and then pressing the Numeric

Keys

˚ that correspond to the station’s frequency.

The desired station will automatically be tuned.

NOTE: When the FM reception of a station is weak,

audio quality will be increased by switching to Mono

mode by pressing the

FM Mode Button (ß until

the

Stereo Indicator H goes out.

min

OFF

Harman/Kardon HK 3380 [14/20] Operation

Содержание

Похожие устройства