Clatronic KA 3756 [37/64] De scaling
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Clatronic KA 3756 [37/64] De scaling

Clatronic KA 3756 [37/64] De scaling
KA3756_IM 15.06.20
37
Electric Connection
1. Ensure that your mains power corresponds with the
specications of the appliance. The specications are
printed on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet.
Initial Operation
Before making coffee for the rst time operate the appliance
twice with clean water only and without paper lter. This
removes dust, which may have collected during transport.
Follow the instructions given under “Operation”.
Turning the Appliance On / Off
• Press the “ ” switch in order to turn on the appliance.
The button must snap in. The operating control lamp
lights up.
• Press the “ ” switch in order to turn off the appliance
or to cancel the brewing process. The operating control
lamp turns off.
Operation
1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups
of coffee into the rear water tank. You can determine the
water level with the help of the scale in the water tank.
NOTE:
You can use the pot to ll the water tank. To open
the lid of the pot, press the two latching lugs together
simultaneously.
CAUTION:
Do not overll the tank! Do not ll it above the MAX
mark.
3. Insert the lter holder. One of the two handles must be
on the right hand side and the other on the left. Push the
lter holder down until it snaps in.
4. Turn over the lower fold of the paper lter (size 1 x 4) and
place it in the lter funnel. Then ll it with coffee powder.
NOTE:
Do not put too much coffee powder into the lter to
avoid spillage.
5. Now close the lid of the water tank. It must snap into
place.
6. Place the lid on the pot. The button on the lid must face
the handle. Note the recesses on the opening of the pot
and the latching lugs on the lid. The lid must snap in.
7. Place the pot onto the storage surface.
CAUTION: Drip stop
Your appliance comes with a drip stop. It closes when
removing the coffee pot. This prevents the coffee from
dripping onto the warming plate if there is still water in
the lter.
• Ensure that the lid is attached to the coffee pot. It
opens the drip stop.
• If there is still water in the tank, place the pot un-
derneath as soon as possible. Otherwise the lter
might overow.
8. Switch on the appliance. The operating control lamp
lights up.
NOTE:
The appliance will switch off automatically a few seconds
after the brewing process has ended. The operating
control lamp turns off.
After the Brewing Process
• When no more coffee is owing through the lter you can
remove the pot.
• Press the button on the lid, if you wish to pour coffee
from the pot.
NOTE:
The lter holder can be removed from the coffee machine
by using its handles on the right and left side.
This makes it easier to dispose of the old coffee lter, for
example.
WARNING:
If you would like to prepare another pot of coffee right
away, wait about 5 minutes after the brewing process
has been completed. Allow the appliance to cool down,
with its water tank open, to prevent hot splashes of water
when lling up the water. If the appliance is still too hot,
a thermostat prevents it from being switched on again
immediately.
De-scaling
De-scaling is necessary when the brewing time increases
substantially.
• Use only commercially available citrus acid-based de-
scaler.
• Follow the recommended instructions for use.
WARNING:
• Afterwards you should boil fresh water in the pot
three or four times in order to rinse out residues of the
de-scaling agent.
• Do not use any coffee powder!
• Do not use this water for consumption.

Содержание

Похожие устройства

Скачать