Elenberg MG-2035D [18/27] Grounding installation

Grounding Installation

DANGER

Electric Shock Hazard Touching some of the internal components can cause serious personal injury

or death.Do not disassemble this appliance.

WARNING

Electric Shock Hazard

Improper use of the grounding can result in electric shock. Do not plug into an outlet until appli-

ance is properly installed and grounded.

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the

risk of electric shock by providing an escape wire for the electric current. This appliance is

equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged

into an outlet that is properly installed and grounded.

Consult a qualified electrician or serviceman if the grounding

instructions are not completely understood or if doubt exists as to

whether the appliance is properly grounded. If it is necessary to use

an extension cord , use only a 3 -wire extension cord that has a 2-

pronged plug with a grounding slot & 2 grounding plates .A 2-slot

receptacle , with a grounding prong or grounding terminal(s), will

accept the plug of the appliance.

1. A short power-supply cord is provided to reduce the risks resulting

from becoming entangled in or tripping over a longer cord.

2. If a long cord set or extension cord is used: 1)The marked electrical rating of the cord set or

extension cord should be at least as great as the electrical rating of the appliance. 2)The exten-

sion cord must be a grounding-type 3-wire cord, and 3)The long cord should be arranged so that it

will not drape over the counter top or tabletop where it can be pulled on by children or tripped over

unintentionally.

CAUTION Personal Injury Hazard

It is hazardous for anyone other than a compentent person to carry out any service or repair

operation that involves the removal of a cover which gives protection against exposure to

microwave energy.

See next page for further instructions «Materials you can use in microwave oven or to be avoided

in microwave oven.» There may be certain non-metallic utensils that are not safe to use for

microwaving. If in doubt, you can test the utensil in question following the procedure below.

Utensil Test:

1. Fill a microwave-safe container with 1 cup of cold water (250ml) along with the utensil in question.

2. Cook on maximum power for 1 minute.

3. Carefully feel the utensil. If the empty utensil is warm, do not use it for microwave cooking.

4. Do not exceed 1 minute cooking time.

Utensils

Two-round-pin plug

Utensils