Oleo-Mac PW 300 HС Инструкция по эксплуатации онлайн [20/120] 91846

Oleo-Mac PW 300 HС Инструкция по эксплуатации онлайн [20/120] 91846
24
5 op e r a t I o n
WARNING
e high pressure cleaner must be used with care and attention. It is your responsibility to make sure that any infrequent
users have read these instructions and are acquainted with the operation of the water cleaner; otherwise do not allow
others to use the high pressure cleaner. Water cleaners must not be used by children or by unauthorised personnel.
Comply with the safety warnings in the operating and maintenance instructions of any optional accessories to be
used.
Do not use the high pressure cleaner if:
- the power supply cable or other important parts such as the high pressure pipe, the safety devices, the cleaner gun
and the lance are damaged;
- the high pressure cleaner has been tipped over or has been bumped;
- there are obvious leaks of water.
In these circumstances, the water cleaner should be tested by a Skilled Technician.
It is especially important to pay great attention when the high pressure cleaner is used in areas where there are moving
vehicles as these can crush or damage the power supply cable, the high pressure pipe, the cleaner gun etc.
During operation, never leave the water cleaner unattended and make sure it is out of childrens reach. Pay particular attention
when using it in kindergartens, nursing homes and old people’s homes, as unsupervised children, elderly people and disabled
people may be present in such places.
Before using the water cleaner, make sure it is in a dry place and that it is in a flat and stable position in order to
avoid accidents and prevent it from falling over.
Before moving the water cleaner, follow the instructions in the “Switching off” section.
Before starting the water cleaner, put on clothing which guarantees adequate protection against the possibility of
incorrect manoeuvres of the jet of pressurised water. Do not operate the water cleaner near people unless they are also
wearing protective clothing.
High-pressure jets of water can be dangerous if they are not used properly. Do not point the jet in the direction of
people, animals, and energized electrical appliances or towards the water cleaner itself.
Hold the cleaner gun firmly during use: when operating the lever (24), the operator is subjected to the backlash of
the high pressure. e power of this recoil is indicated in the table of technical specifications (recoil is expressed in N,
where 1 N = 0.1 kg).
Do not point the jet towards oneself or other people in order to clean off clothing or footwear.
To protect the environment, vehicle engines and machinery with oil-pressure circuits must only be cleaned in areas
with a suitable oil trap.
Vehicle tyres must be cleaned at a distance of at least 50 cm/19 in to safeguard them from being damaged by the high-
pressure jet. e first evidence of damage to a tyre is a change in colour.
Do not point the high-pressure jet towards materials, which contain asbestos or other harmful substances.
Do not use the water cleaner in the rain.
Pay particular attention to the instructions in the Checks and connection to the mains electricity supply
section.
Pay particular attention to the instructions in the “Use with detergents” section.
When the water cleaner is not in use, do not leave its plug in the power outlet and disconnect it before any activity.
More precisely, make sure that the mains switch (2) is in position “0”, remove the plug from the power outlet, press
the lever (24) on the cleaner gun to eliminate any remaining pressure and bring the safety catch in its locked position
(25) (Fig. 1 - position S):
- before leaving the high power cleaner unattended, even for only a short time;
- after use;
In addition, wait until the high pressure cleaner has completely cooled down before cleaning or maintenance.
During use, do not lock the lever (24) on the cleaner gun in the open position.
Do not remove the plug from the power outlet by pulling on the power supply cable.
Do not put any reducers or adaptors between the electric plug and the power outlet.
Keep the power supply cable, any extension cords, the plugs and the outlets dry. Do not touch them with wet hands.
If the supply cord is damaged, it must be replaced by the Manufacturer or by a Skilled Technician, in order to avoid
a hazard.
If, due to any reasons, the plug is cut from the power supply cable, there is the risk of electrical shock in case it is inserted
in any home socket. To avoid this ranger, it is necessary to immediately eliminate the cut plug.
If the device is equipped with a 13 A plug conforming to standard BS 1363, it is necessary to observe what follows:
- do not use the device if the fuse cover is not present: in case it was lost, the spare cover can be ordered to the
service centre

Содержание

Похожие устройства

Скачать