Al-Ko Easy Crush МH 2800 [20/180] Disposal

Al-Ko Easy Crush МH 2800 [20/180] Disposal
en
Working behaviour and working technique
20 Easy Crush MH 2800
CAUTION!
Damage to the machine due to improper
operation!
Incorrect handling can result in machine
damage!
Only feed materials to be shredded af-
ter the machine was switched on. Do not
feed materials to be shredded after the
machine was switched off.
WARNING!
Risk of injury due to revolving tools!
Revolving tools can cause severe hand
and finger injuries!
When working on the cutting tool, discon-
nect the machine from the mains con-
nection, wait for the tool to stop moving,
and wear protective gloves.
WARNING!
Risk of injury due to long materials to be
shredded!
Longer materials to be shredded can
strike out and cause injuries!
Maintain sufficient safety distance.
WARNING!
Risk of injury due to negligence!
Loss of balance due to negligence can
cause most severe injuries!
Never feed the shredder from an eleva-
ted position.
DISPOSAL
Do not dispose of old
equipment,batteries or accumulators
as householdwaste!
Product, packaging, and accessories
were made with recyclable materials, and
should be disposed of accordingly.
TROUBLESHOOTING
Malfunction Possible cause Solution
Grass catcher missing or not lo-
cked.
Push grass catcher in completely
and lock it.
Mains socket (house installation)
defective.
Use different mains socket.
Motor does not start.
Extension cable defective. Check cable and replace it as nee-
ded.
Grass catcher overflowing (mate-
rial backing up in the cutting unit).
Empty grass catcher and remove
materials to be shredded from the
cutting unit as needed, see "Re-
leasing a cutting disk blockage".
Machine does not pull in
materials to be shredded.
Shredder blade clogged with wet
materials to be shredded.
Remove clogging by feeding
branch material.
Materials to be shredded
are not properly cut.
Blades dull or damaged. Turn or replace blades, see "Re-
placing/turning the shredder bla-
des".
Motor switches off. Motor protection switch switched
off due to cutting disk overload or
blockage.
The motor can be switched on
again after a cool-down phase of
approx. 5 minutes.
Unusual noises.
Rattling on the machine.
Screws on the motor, its mount,
the carriage or the shredder blade
are loose.
Re-tighten screws.

Содержание

Похожие устройства