Samson Meteor Mic [11/24] Installing the meteor mic

Meteor Mic · USB Studio Condenser Microphone

Installing the Meteor Mic

clicking on the number box. If you nd that the microphone red clip LED is lighting frequently,

turn this control down until the LED no longer ashes red.

5. Select the Playback tab, then select the Level tab and set the computer’s Master Volume to

100%. Use the Meteor Mic’s front panel Volume knob to control the overall output from the

headphones or speaker.

6. Adjust the direct monitoring level in the Playback tab by moving the fader labeled Micro-

phone. A good place to start is to set the monitoring level equal to the microphone gain.

Remember that the monitoring level is not the same as the microphone gain. If the input

signal is clipping, lower the microphone gain.

Windows XP

1. The rst time you plug the Meteor Mic into a USB port, Windows will install the universal

drivers for that port. A balloon will pop up, telling you the computer has “Found new Hard-

ware.”

2. When it is nished installing the drivers, a balloon pop up will say “Your new hardware is

installed and ready to use.”

Note: This balloon will only pop up when you rst plug the device into a particular USB port.