Maxwell MW-3804 W [8/36] English

Maxwell MW-3804 W [8/36] English
8
ENGLISH
necessary and understandable instructions by the
person who is responsible for their safety on safety
measures and information about danger that can be
caused by improper usage of the unit.
• Do not use the unit outdoors.
• Never pull the power cord, when disconnecting the
unit from the mains, take the plug and carefully pull it
out of the socket.
• To avoid damages transport the unit only in original
package.
• Never use the unit if the power cord or the power plug
is damaged, if the multicooker works improperly or
after it was dropped. Do not try to repair the unit by
yourself. Contact an authorized service center for all
repair issues.
• Keep the unit away from children in a dry cool place.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE
ONLY
USING OF THE COOKING BOWL (14)
• Use the multicooker and all its parts for the intended
purposes only. Do not use the cooking bowl (14) with
other heating units or cooking surfaces.
• Do not replace the bowl (14) with any other container.
• Always make sure that the heating element (12)
surface and the bottom of the bowl (14) are clean
and dry.
• Do not use the bowl (14) for mixing products. Never
chop products in the bowl (14) to avoid damage of the
non-stick coating.
• Never leave or keep any foreign objects in the bowl
(14).
• When cooking stir the products in the bowl (14) only
with the plastic soup ladle (16).
• Do not use metal objects that can scratch the non-
stick coating of the bowl (14).
• After cooking dishes with spices and seasonings
wash the bowl (14) right after cooking.
• To avoid damage of the non-stick coating do not put
the bowl (14) into cold water right after cooking; let it
cool down preliminarily.
• The bowl (14) is not intended for washing in the
dishwashing machine.
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature it is necessary to keep it for at least
two hours at room temperature before switching on.
Unpack the unit, remove any stickers and package
materials that can prevent multicooker operation.
Place the multicooker on a flat, heat-resistant surface
away from all kitchen heat sources (such as gas
cooker, electric cooker or cooking unit).
Place the unit keeping at least 20 cm gap between
the multicooker body and the wall and 30-40 cm gap
above the unit.
Do not place the unit close to the objects that can be
damaged by the released steam of high temperature.
Attention! Do not place the unit near bath tubs,
kitchen sinks or other containers filled with water.
Remove the steam release lid (9) pulling it upwards.
Open the lid (6) by pressing the button (7).
Wash all the removable parts - steam release lid (9),
bowl (14), basket for steam cooking (15), soup ladle
(16) and measuring cup (17) - with a soft sponge with
neutral detergent, then rinse under running water
and dry.
Clean the unit body with a damp cloth and then wipe
it dry.
Install ste
am release lid (9) back to its place.
USING OF THE MULTICOOKER
Load the ingredients in the bowl following the recipe
(see “Recipe book”).
Note: make sure that the products and liquids level
doesn’t exceed the level of maximal mark “10” and
is not lower than the level of minimal mark “2” The
maximal mark for porridges, except rice, is defined
by the mark «8».
General example of loading products (as an
example cereal is considered) with required water
amount.
Measure cereal with the measuring cup (17) (one
measuring cup contains approximately 160 g cereal),
wash it and place in the casserole.
Add water up to the corresponding level.
- For simplicity use the graduated scale in cups (CUP).
The scale has graduation, indicating proportions for
cereal and water.
For example:
- If you put four measuring cups of cereal, pour
water up to the mark «4 cups (CUP) ».
- For cooking of thin milk porridges the recommended
proportion of rice and water is 1:3.
If you steam products, pour water into the bowl (14)
so that boiling water doesn’t reach the bottom of the
basket (15). Put the basket with food (15) into the
bowl (14).
Place the bowl (14) in the process chamber. Make
sure that the bowl is placed evenly and has a tight
contact with the heating element (12) surface.
Notes:
Do not use the bowl (14) for washing cereals and
do not chop products in it, this can damage the
non-stick coating.
Make sure that there are no foreign objects, dirt
or moisture in the process chamber and on the
bottom of the bowl (14).
Wipe the outer surface and the bottom of the
bowl (14) dry before use.
In the middle of the heating element (12) there is
a device for switch-on blocking, if the bowl is not
Скачать