Luxstahl MARCO Maxibrew-Twin [5/8] Note a brew can still be selected after all the hot water has been drawn off the hot water tap while the machine is brewing however the hot water recovery rate is re...

1900064 REV.2 Page 5 of 8

 A brew should only be selected whenever the green ‘Ready to brew’ lights are

illuminated in order to produce the highest quality of coffee possible. (the brew light

turns on when there is enough water at the correct brewing temperature. If there is

enough water yet it is not at optimum temperature, it is possible to brew but the brew

light will not be illuminated)

 Left and right brews can run simultaneously (although the two brew buttons should not

be depressed at exactly the same time. Press and release one brew button before doing

the same on the other side).

HOT WATER:

 When the machine is full, up to 17.5 pints/10 litres of water is available for tea etc. If all

this water is used and no water is available at the hot water tap, the machine should be

left for a short while to recover (Heat-fill mode).

 Using hot water at a faster rate than the machine can recover will result in a temperature

drop in the beverage (Continuous fill mode).

Note: A brew can still be selected after all the hot water has been drawn off the hot

water tap. While the machine is brewing, however, the hot water recovery rate is

reduced and the machine will take longer to replenish the hot water supply.

LOCK FUNCTION:

 The Qwikbrew 2 Twin has a button lock function to prevent untrained personnel

operating the machine, or accidental misuse by trained personnel. If the lock button (left

hand side control panel) is pressed for approximately 6 seconds, a red light next to the

button will illuminate. Both control panels are now ‘locked’. No buttons are operational

when the lock function is enabled. The machine will operate as normal, i.e. if the

machine is brewing, it will continue to brew. Once completed another brew cannot be

selected until the lock is disabled.

Note: The ‘Ready to Brew’ lights will still be on, but no brew will be able to be selected.

 To disable the lock function – hold the lock button for approximately 6 seconds once

again.