Victoria Arduino Adonis 2 Gr [67/136] Steam flow adjustment

6.5 STEAM FLOW ADJUSTMENT

Use the lever to increase/reduce the flow of steam

injected into the milk, as illustrated in the following figure.

NOTE

Before using the steam wand, always bleed out any

condensation for at least 2 seconds or according to the

manufacturer’s instructions.

6.6 ADJUSTING THE TURBOCREAM

NOZZLE

(If Fitted)

To increase/reduce the amount of air injected into the

milk from the TurboCream nozzle (and therefore to

increase/reduce the amount of foam in the heated milk)

proceed as illustrated in

Fig. 17:

① Loosen the stainless steel tube (1) as illustrated in

Fig. 17.A.

② To increase/reduce the amount of air, tighten (turn-

ing clockwise) or loosen (turning anticlockwise)

the Teflon tube (2) as illustrated in Fig. 17.B.

③ Tighten the stainless steel tube again.

NOTE

By reducing or increasing the length (tightening or

loosening) the tube/Teflon tube by a few fractions of a

mm/mm, there is a significant difference in the amount

of foam in the heated milk.

Fig. 17

Fig. 17.A

Fig. 17.B

Fig. 16