Beurer LR200 [16/82] Initial use

Display and buttons

ON/OFF FILTER RESET I II III ION SLEEP 2H 4H 8H

1 ON/OFF button

Switches the device on/o

If the light below “Filter reset” is ﬂashing, change

the ﬁlter. After changing the ﬁlter, hold down the

on/o button to reset the ﬁlter change display.

3 Ioniser/Sleep mode

Switching the ioniser or night mode on/o..

2 FAN SPEED button

The air cleaner has three fan speeds: I (low), II

(medium) and III (high).

4 TIMER button

The air cleaner features a timer function that you

can use to determine the number of hours the

air cleaner should run for before it automatically

switches itself o. The air cleaner has three timer

periods: 2H (two hours), 4H (four hours) and 8H

(eight hours).

5. Initial use

5.1 Removing the air cleaner

1. Open the cardboard packaging.

2. Remove the device from the top of the box without opening the ﬁlm bag.

3. Now remove all plastic ﬁlms. Remove the combi ﬁlter from the device (see “Filter change” section) and

take it out of the plastic ﬁlm. Then re-insert the combi ﬁlter into the device.

4. Check the device, mains plug and cable for damage.

5.2 Setting up the air cleaner

1. Place the air cleaner on a ﬁrm, level surface to prevent vibrations and noise.

IMPORTANT

If you wish to reposition the air cleaner, only carry it by the handle on the rear of the device.

2. Set up the air cleaner in such a way that there is at least 30 cm clearance on all sides.

3. Make sure that the air inlet and air outlet are never blocked.

6. Operation

6.1 Switching on the air cleaner

1. Always follow the instructions in chapter “5 Initial use”.

2. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.

3. Press the ON/OFF button (

) to switch on the air cleaner.