Pilotage Юниор Fighter RC8677 [10/20] Charging the model

www.pilotagetoys.com

Model Assembly

Charging the Model

1) Make sure that the Tx switch is in the

“OFF” position.

2) Make sure that the Rx switch on the bottom

of the model is in the “OFF” position.

3) Open the charging door on the Tx and

extend the charging lead.

4) Plug the charging lead into the charging

socket on the model.

IMPORTANT: DO NOT FORCE, the charging lead

will easily t into the socket in only one way!

6) Monitor the model until the green charge

LED turns o.

Note: There are vents on the Rx and Tx to

disperse heat during the charging cycle;

make sure that free access to fresh air for

these vents is not blocked. Charging time

is approximately 30 minutes.

5) Once the charging lead has been properly

attached to the socket, the green charge

LED will illuminate on the Tx.

1) Apply the stickers to the model.

2) Connect the clip from the wing to the corresponding socket in

the fuselage.

3) Test t the wing to ensure that it will be properly placed prior to

removing the protective paper from the adhesive.

4) Remove the protective paper from the fuselage to expose the

wing mount tape.

5) Turn the fuselage over so that the cockpit faces the ground, then

tuck the connector and wires into the fuselage cavity.

6) Attach the wing to the fuselage with the adhesive tape that is

pre-installed in on the fuselage portion. Your model is now fully

assembled!

Green Charge LED

Vents

TX and RX are in “OFF”

7) Return the charge lead to its

compartment in the Tx.