Soundcraft Si Performer 2 [104/135] Reverb parameters

User Manual

10.1.1: REVERB PARAMETERS

LEXICON FX > REVERBS > REVERB PARAMETERS

10.1.1: LEXICON FX > REVERBS > REVERB PARAMETERS

Shape

Adjust the 'contour' of the reverberation envelope.

With Shape all the way down, reverberation builds explosively, and decays quickly. As Shape is advanced, rever-

beration builds up more slowly and sustains for the time set by Spread. With Shape in the middle, the build-up

and sustain of the reverberation envelope emulates a large concert hall (assuming that Spread is at least halfway

Initial echo density.

High settings of Diusion result in high initial echo density, and low settings cause low initial density. In a re-

al-world situation, irregular walls cause high diusion, while large flat walls cause low diusion. For drums and

percussion, try using higher Diusion settings.

Bass Bst - Bass Boost

Boost or cut frequencies below the Bass Boost Frequency (the transition point from Mid Rt

to Low Rt).

The amount of boost or cut required is highly dependent on the material being processed.

RT Hi Cut - Reverb Time High Cut

Set the frequency of a 6dB/octave low-pass lter on the reverberated signal.

create darker reverbs with more bass frequency emphasis.

Hi Cut

Adjust the amount of high frequency content in the reverberation tails.

Higher frequency settings increase high frequency response, creating brighter reverbs; lower frequency settings

create darker reverbs with more bass frequency emphasis.