Boss EQ-200 [12/16] Appendix

Appendix

Returning to the Factory Settings

(Factory Reset)

Here’s how to return the EQ-200 to its factory-set state.

1. While holding down the [ON/OFF] switch and

[MEMORY] switch, turn on the power (insert a

plug into the INPUT A jack).

The display indicates “FACTORY RESET.”

2. Press the [MEMORY] switch.

The display indicates “ARE YOU SURE?.”

If you decide to cancel, press the [ON/OFF] switch.

3. Press the [MEMORY] switch.

The factory reset is executed.

4. When the display indicates “COMPLETED,” turn

the power o and on again.

Installing Batteries

Insert the batteries as shown below, being careful to

orient the batteries correctly.

* Batteries should always be installed or

replaced before connecting any other

devices. This way, you can prevent

malfunction and damage.

* If operating this unit on batteries,

please use alkaline batteries.

* Even if batteries are installed, the

unit will turn o if you connect or

disconnect the power cord from the

AC outlet while the unit is turned on,

or if you connect or disconnect the

AC adaptor from the unit. When this

occurs, unsaved data may be lost. You

must turn o the power before you

connect or disconnect the power cord

or AC adaptor.

* When turning the unit over, be careful so as to protect the buttons and

knobs from damage. Also, handle the unit carefully; do not drop it.

* If you handle batteries improperly, you risk explosion and uid leakage.

Make sure that you carefully observe all of the items related to batteries

that are listed in “USING THE UNIT SAFELY” and “IMPORTANT NOTES”

(leaet “USING THE UNIT SAFELY” and Owner’s manual).

* “BATTERY LOW” will appear on the display if the batteries are low.

Replace them with new ones.