ASHLY MQX-2310 [7/12] Installation

Operator Manual – MQX-2310 Equalizer Page - 7

Installation

Use four screws and washers when rack mounting the Equalizer. For mobile use, the unit

should be further secured as appropriate.

General Requirements

MQX Equalizers have specific physical, electrical and signal requirements for proper

operation. These requirements will vary depending on your specific application, setup, and

the settings on the Equalizer. When setting up and testing your system, please take special

care to double check all connections and settings. Please refer to the specifications section

of this manual for specific input, output and other figures.

AC Power

Your MQX equalizer should be connected to a standard 3-wire grounded electrical outlet

supplying 100-240 Volts, 50-60 Hz. To reduce the risk of ground loop hum, connect all

audio equipment to the same electrical power source. Do not remove the AC plug ground

pin, as a potential shock hazard could result.

This unit will perform normally within the AC voltage range specified above. Voltages

less than this, as found in “brown-out” conditions, may reduce performance. No user

serviceable parts are inside the chassis. Refer all servicing to qualified service personnel.

Overall power consumption is less than 30 watts.

NOTE: The power switch does NOT isolate the appliance from mains. Make sure the mains

power socket or an alternative disconnect device is near by and easily accessible. When the

product is connected to mains, the line-filter and the input of the fuse are energized.

Introduction - 4

MQX Equalizers – 5

Connectors & Cables – 5

Physical Description - 6

Installation – 7

General Requirements

AC Power

Typical Applications - 8

Troubleshooting - 9

Dimensions - 9

Specifications - 10

Warranty - 10